开云体育

No pre-compiled binary, but I do have a branch (and outstanding pull request) for a much faster version:

does yours allow selection of 17 m band? if not maybe a newer faster one might have that fix in it as well

Just built my uBitx v6, I cannot believe how slow the display is. Could someone post a compiled HEX of the faster firmware. Philip G7JUR

Mine turned up with damage. The volume pot broken off the the board, marks on the touch screen, and damage to the corners of the case. Also chipped paint work. Philip G7JUR

And I, for one, do not want the group to fracture into subgroups at all. I find all emails about the uBitx and Bitx40 relevant, not only to their respective radios but across versions. I do not want

Hi Andy, 12V @ 6A?is good, but doesn't actually indicate how "fast" your power supply is. Power supplies have ramp up times and response times that determine how "fast" they are. I agree that not

V 1.27 no mods, except fuse at 12v input.? Checked R133 and R134 and both show open.

Hello folks, Attached is draft Noobie guide pdf version for comments/improvements. If my bricked rig solution is repairable using software re-install I will add that procedure to end as well. I'd like

No need to apologise for a lack of knowledge Andy. I think this group was designed to gain knowledge. Keep on with your vision. 73s Ken T VK2HXX

I have a dedicated 12 VDC @ 6 Amps supply for the uBITx transceiver with no other load on it.? The only thing I noticed in past sessions after connecting to laptop via USB port was that if I shut off

The white screen at power on is something I saw in my development too: /g/BITX20/topic/ubitxv6_bricked/69359467?p=,,,20,0,0,0::recentpostdate%2Fsticky,,,20,2,40,69359467 Seems like

First of all, let me clarify something here to eliminate confusion.? The TSW Teensy 4.0 to NANO adapter I mentioned to start this thread has NOTHING to do with the RobotDyn SAMD21 board some of you

I recently saw a couple of posts that mentioned a 4 port USB expander/extender was used with UBITx xcvr. I am interested in the details of how it was installed to be used. The one expander I have

In my vigor and enthusiasm to learn the arduino tools and Xloader I appear to have completely lost the display; all I get is a blank white screen and it does not enter the setup screen when I power it

Hi Evan, My webpage is hosted for free on a private server and the host has asked I not put any PayPal links on the page for whatever reason. You can still order via PayPal by emailing me your request

I ordered a uBITX case kit from Sunil at amateurradiokits.in several weeks ago. After ordering the standard case, I realized I wanted to upgrade to the NEXTION 5 inch one.? ?My confused ordering

The thing that made me nervous about it was they didn't say it was compatible with the Arduino IDE or its libraries.? If it was compatible, they would have said that. Jack, W8TEE

Thanks Kees, The only drawback we've found is that you can only use 3.3V compatible I/O as the Teensy 4's input/output pins are NOT 5 volt tolerant. Bear that in mind when using it. We spell that out

Evan, My webpage's host (private server) has requested I NOT put a PayPal link on the page - he is feuding with them. You can order by sending the listed fee via PayPal to w0eb@... Jim, W0EB

The RobotDyn SAMD21 board looks similar, but is not a Nano plug in replacement. For starters, there are 14 pins on each side vs 15 on the Nano. The Raduino uses all available Nano pins, so the