In my vigor and enthusiasm to learn the arduino tools and Xloader
I appear to have completely lost the display; all I get is a blank
white screen and it does not enter the setup screen when I power
it up with the tune button help. I believe the term that describes
effect of my experimenting is "BRICKED" hihi
Prior to current state I had managed to receive CHU Canada time
signal on 3330 KHz ; audio quality wasn't great due to BFO but
definitely rx was finally working OK.? Had confirmed TX and RX
were both functioning OK and moved onto code fam to be able to
access software and software settings. Turned it all off to go to
bed and this morning just a blank white screen on power up.
Hence my humble request for some assistance in de-bricking it !
So where might I find a link to download the latest V6 full
software install and maybe a step by step description of how to
install it properly again. Also Memory Manager and software
settings manager software for V6
Thanks
Andy
On 2020-01-07 07:57, Evan Hand wrote:
toggle quoted message
Show quoted text
Andy,
I have found that the BFO adjustment will make the uBitx sound
terrible, tinny and full of high pops. Adjusted properly, the rigs
(I have 3) all sound good.? Not great like my IC-7300, but good.
I would recommend trying the attached procedure, assuming that you
have a device with internet and mic capability.? It works well,
and will let you know visually that the rig's BFO is adjusted as
best it can be.
NOTE: you will need a microphone connected and allow access to it
to use the audio spectrum analyzer on the HFSignals web page. It
works with my ipads and iphones if you do not have a pc/laptop
with mic.
Original post from Farhan:
/g/BITX20/message/74079
73
Evan
AC9TU
