开云体育

It looks like you already got the info you needed. Typically the outer conductor is always ground, and the chassis of a device is ground as well. Personally, I prefer Anderson Power pole connectors,

hello men? i have had enough unless i can find a way to reset and reload? this ubitx v5? will be on ebay as a project for someone? is there a way to completely reset this radio? and a step by

Thanks Dave for your interest. The Board and additional parts are on their way to you. Thanks for everyone else's replies. Best wishes Derek G4VWI.

Some people do not realize to reach the price point, the ubitx must be bare bones. All these features look good and most likely attractive features and your cost goes up. These brings you into a

Does that work by saturating the toroid?

Jim, more power to you! I hope you were able to benefit a lot of people. Overtime, we changed a few of the resistor values to make the system work a little better. You may see this in various

Gordon, Just like you said - I sent the zipped gerber files you referenced to jlcpcb.com.? With my first order discount they are sending me 5 boards for only $10.? Delivery time 4 business days.? I

So ..ran across this circuit the other day ..thot maybe those who might be looking at alternative agc circuits as well as transmitter alc? might be interested xmitter alc I would place the circuit at

I Meant to suggest on some future revision X of Ubitx, a PCB layout to place a 3-5 mil wide? about 1.5" or 35-40 mm long trace from FET finals to round through hole for wire from PCB to RF

Anyway...my bias is at 110ma per side.? Does that seem appropriate for 24v?? What got you to 36v? What happens to your output power as you increased from 12v to 36v? Thanks for any insight!! Don

Yes, I used the mic button, but my antenna tuners will not tune when the mic button sends dots.? I must switch to Hand Key for a steady tone and then use the mic button (or key). Bert N8NN

Thanks to all of you! I soldered the proper connections and powered up the transceiver with a dummy load. Everything seems to be working correctly, but not prepared with proper antenna yet to make

Joel, I do not have a v6 uBitx, so do not have direct experience with that specific kit.? I do have both v4 and v5 boards, and all do run the regulator hot, especially if I use a 13.8 volt "big rig"

Bert, Thanks for the suggestions. Btw, you can key with the ptt as well. This is in case you need to tune up. One evening, I found Nicaragua on 40m cw and I didn't have the key with me! I quickly

I know program space on the Nano is limited.? I recommend some changes to CW operation. 1.? Eliminate CW Keyer portion of the Setup menu and replace it with the function described below.? Eliminate

good deal!

There is finally a reverse voltage protection on v6. - f

Porting to Nextion is not very difficult. You have to write three main routines : one to draw a rectangle of a colour, another to draw a character and another to report where a touch has happened. The

Thanks Matt. Very helpful. Now to find a replacement for the raduino. -- Mike VK3XL

Thanks Gordon, I will do some searching. -- Mike VK3XL