开云体育

You and I were concerned if the unit would run after I dropped the ubitx to the floor. I think that we should be happier that the unit runs as opposed to all these faulty rigs described in the emails

Hello men I have just returned to playing with my ubitx ?after a break for my sanity .I managed to get the display back on ?but it would appear that the firmware has not loaded properly as I can not

Hi Bert, I have discovered on V6 that when you switch between LSB and USB nothing happens until you click the encoder knob one way or the other. Joel N6ALT

This rig is still available. Any interest?? Thanks, Kevin NZ1I

I assembled my V6 full kit today.? No nut for the BNC connector, no sticky on the feet and the feet are too large to work with screw positions, volume knob can be attached but just barely.? Those

My V6 arrived yesterday afternoon. I assembled it that evening, hooked up an antenna and power supply, and took it for a receive-only spin. I ran the audio-out into my laptop and monitored FT8 with

60C degrees don't seem to me really too hot but actually I have no much experience with finals. The CPU temperature of my laptop is about 75C degrees.

I agree.EXCEPT I screwed the feet on, the screws were short, so I pushed.. and put the head of the screw all the way thru the foot.Besides a larger nut for the BNC, I will get 4 stick on feet.And I

See comments below: OK OK That's AFAIK

It has the heat sink screwed on and is tight, the fact that the heat sink is so hot means it's working, it's transferring the heat. Maybe I'll change the regulator to a new one to and see if it runs

To start off, this is not me complaining, it's me trying to help out and fix problems with the board for other people. There are several problems with my ubitx v6 that I got yesterday. I don't think

How would I updat the V6 and what do I need to do it.? Yes, I am a complete noob and old to boot! de N5PU

Any user instructions for the V6 firmware....No info anywhere about cal settings and so on...... -- David N8DAH Kit-Projects.com ( http://www.kit-projects.com ) Shop is open! (

Mine is at 114 F Bit hot. -- David N8DAH Kit-Projects.com ( http://www.kit-projects.com ) Shop is open! ( Https://Shop.Kit-Projects.com )

+1 for missing BNC nut. The 1/8" (3.5mm) jacks on the front included nuts, but the jacks don't extend far enough to secure the nuts on the front panel. Not a problem, but now I've got three tiny nuts

I hope the heatsink is clipped on. I have been running the radio continuously for a month now. No harm done. In an earlier version, I was using a switching regulator. It was horribly noisy. I just

“Tighten the large nut around the BNC socket.” I received two “large” nuts. Put one on the Encoder. Since both are the same size nuts, it would not fit on the BNC socket. The packing slip for

That’s great. I went looking for V6 assembly instructions. I, for some reason never found these. Thanks, Kent KQ4Kk Sent: Friday, December 27, 2019 11:57 AM To: [email protected] Subject: Re:

Hi all, I have my V6 all hooked up and calibrated and have checked into a few nets with my own home brew mic, the supplied one got bad reports, however I have noticed that the 5 volt regulator heat

There is a photo that shows correct placement in the assembly instructions, step 4, 5 and 8 show the connection to the display board, not the main board.