开云体育

There are also differences in the "CONTROL" connector.? This means you need to rewire that connector as well.? The only connector on the v6 Raduino that has not changed from the v4/5 is the

No, the need never came back up. I could use WSJT-X if I wanted to control and the Flrig was basically for fun and maybe use Fldigi at some point. I see the fl*** programs get updated a lot, so maybe

Jerry -- thank you for the clever application for my excess 510 and thermal switches. Love it. Don km4udx

I had previously written: Wrong.? The connector from Raduino into the display is different, has 14 pins instead of 16 for starters. Power and ground have moved so attempting to plug a 2.8" TFT into

On Fri, 20 Dec 2019, 2:52 am Jim Sheldon, <w0eb@...> wrote: > Yes. V6 doesn't use an LCD at all. It uses one of the 2.8" TFT color > screens and the pinouts go to a 14 pin connector that's

Vic, I know this is an old thread, did you ever get this to work? Jay WS4JM

Jim: Do you still have the two boards, and the blown out Raduino, they are repairable. Howard

Is there a cost effective way to add band switching? The scope trace showing on the page seems pretty good. W5ALX http://blueridgediscovery.org [email protected]> wrote:

Hi Patrick, I sent you a reply this morning by private messaging on this board. Perhaps you did not receive it. Jonus needs the board only. Perhaps I could send it to him directly and then work out

RD16HHF1 and heatsink out - is much better than RF510 inside the room.

Don, So you have temp sensors that turn off when they get hot, and a bunch of extra IRF510's? An excellent opportunity to better understand what an IRF510 does! Here's the data

I am also having the same buzzing as described. I am using the uBitx with a 5" nexion screen, the base package including the audio amp. I have tried 2 different power supplies for the touch screen,

Using variable speed fans by running them at 5V for 12V fans and using temperature sensing to speed them up? works well.? ?Save for you cannot touch the heatsinks as they are RF hot so they must be

Mark, Running? at 175C is way too hot for any reliability. Keep it cooler.? That means more heatsink as you pay a 2.5degreeC/per watt of heat dissipated price for the part. At over 100C you need to

Yep I'm sure, If you read his article about the amp, you can see OM Kosser is a really careful designer that worked very hard to make that amp a nice reliable design.? So he was being prudent and

Yes. V6 doesn't use an LCD at all. It uses one of the 2.8" TFT color screens and the pinouts go to a 14 pin connector that's mounted down the right side of the V6 Raduino board. V6 Raduino is the

Apologies for the late reply Steve, Tinkercad lets you export flat drawings for engraving and such. That may suite your needs. However thingiverse i believe has no support for such

After lots of empirical observation, the IRF510 heatsink (w/out mica insulator) can get a lot hotter than 32deg Cel.? And live. Pointing my Lasergrip 774 standoff heat sensor at the TO-220, and at

Erwin, I do agree with you that plastic can be a bit brittle that is why I was looking for a template as I did not want to find a insert replacement when a failure did occur. , I will be very careful

I am software but the wiring on the raduino for the LCD connector is totally different between V5 and V6?