开云体育

There is so much activity on this group that it is hard to keep up with all the activity. Are these AGC boards available only as pre-assembled boards David or do you also offer kits?? I vaguely

If you bought my uBitx, you may have noticed a part is missing. I accidentally left it out of the box. Please contact me, identify the missing part, and I’ll be glad to ship it to you. Sorry! Steve,

My uBITX works great on 40M. However, receive sensitivity is very low on all other bands. 20M & 80M S9+40 signals on my Icom 706 can barely be heard. My first thought was the high pass filter might

I will offer $85.00 shipped and send paypal today K6kwq Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10 ________________________________ Sent: Sunday, June 16, 2019

Shooda thorta thet. With name Dexter, and dextral like most (and fairly dexterous), what else but Sinistral? :) a dextraneous thought there ... 73... ZL2DEX

Don't give up. this is a learning rout. Not sure hwere you got your BITx40 from, but mine from HFSignals.com, was just great. OK the pots were a little cheep and only had 4mm shafts, not the normal

uBITX v3. Unbuilt, in original plastic box.? I started to wire this up, and got distracted by other projects. Has the TDA 2822 audio chip. $95 shipped USPS Priority Mail, U.S. ONLY.? Paypal or check

Perhaps you could post a photo to show what is missing and what you think is wrong?

The Raduino is the same. Connections are different. You can flash the software for the bitx40. Use Allards software. Better than stock.

I am off to a poor start with my Bitx 40. Several parts missing and have discovered they sent the wrong Raduino (for the ubix?} I have sent complaint but no response. Is this typical ?? Maybe I

It is a better idea to trim the dipole to low swr rather than tune it up. Also cheaper.

The dipole is a good antenna, you will likely be able to get a near 1:1 swr with your analyzer. In any case the difference would be almost negligible. In a couple of years, as propagation improves you

Hah! Cheers Ashhar. I do indeed have a sinister hand. Like most lefties, I don't really have a bias when learning new skills, so when I picked up CW, I trained my right hand so I could take notes with

Thanks for the kind words Joel! I think the R70 point is recommended for R4 boards but I defer to the kit-projects guys. I used the volume pot high point. Tune up one of the FT8 frequencies and you'll

I resemble that remark 73 Jack KZ5A

SINISTRA?

I have been on the fence as to whether I was going to want an Antuino, especially after picking up and YouKits FG-01 for a good price in ebay. That blog post from n2htt just changed my mind; I'm now

Definitely not offensive, and for anyone who is a baseball fan, they'll know the origination of the term and how it came to be. And now back to our regularly scheduled ubitx discussion...

HI? all I'm facing a problem with my ubitx V5? i can't change the frequency or going trow the Sub Menu program i changed the? ?KNOBE encoder the same problems the frequency is?frozen and the menu

Ashhar, Thanks for quick response.? Powering up via battery. Getting 9V past switch. ..... Ahh- Found the problem. Bad solder joint on external power connector not allowing negative (ground) lead to