开云体育

I think an si5351 breakout board, a resistor network to combine two channels (some will want all three), and a Nano with LCD and rotary encoder to program the si5351 with is about all you want. Could

I got a replacement Raduino board for? $35 US sent via DHL from HF Signals, which I plan on keeping as a spare. I managed to replace the Nano on my original Raduino board , not too difficult and

Depends on what you mean by SSB modulation. Jerry, KE7ER Hmmm .. Twas just a hair-brained thought .. Two-tone test for sure ubitx stripped of all rx cruft.. everything past t10 or so on xmit side

You may be hearing a carrier because your receiver is very close to the ubitx. Mine has a carrier but it is down about 40 db or so from the signal . I am thinking I measured about 1 milliwatt of

I have overdriven the power chain by having the slider in wsjt-x up too high, resulting in the need to replace components. That’s why I was asking where the drive level was set to, as well as

I'll check on the wsjt-x slider position tonight (already tried various sound driver slider positions, not the wsjt-x one, however).? We have not fully checked out the radio with SSB voice until

Are you sure you have the RF out ground and hot connected properly? Allison

Dennis, you are correct. For many uses the 2n2222/DXT2222 are interchangeable or improved replacement. Allison

Peter, Nice looking build.? I wonder with a different layout if it performs better. Allison

Very nice. So I manually uploaded my little WSJT-X log to qrz.com.? That worked!? Is there a way to automate the WSJT-X interface to qrz.com? And to complicate, I've installed jtxalert, and it wants

Would also try to adopt a modular system , but when stacking the modules any adjustable components should then still be accessible from one of the edges of the relevant module board.? Hence a

Depends on what you mean by SSB modulation. If all you want is is the same effect as an SSB transmitter with a 1khz tone into the mike, most any RF source can do that.? As in any CW transmitter, or

That is a great start with ft8. Here is the qrz log of what I have worked with my ubitx.

I would prefer that it remain here to avoid "fragmentation" ...one stop shopping The software guys seem to be able to ignore most of the hardware discussion ...as I do most of the software and or

-- 2222a Nd 3904 are interchangeable but in my mind, the 2222 is a better grade... not sure I can back that up factually. 72 and God bless KD4EPG

I am looking at N5ESE's Classic RF Probe page. He uses a 0.01 ?F cap and a 1N34A diode. Are?the cap value and diode type critical? Thanks!

Progress I think.? Replaced the 1-AM smd with a 2n3904 and have side tone back (thanks Conrad) but the display has gone off showing black boxes across the top and gibberish when I key.? It had been

When I sow the bottom of the heatsinks were almost touching the board I removed just a piece 1-2mm of the heatsinks. Just to be sure they could not touch the board.

Thank you Marco,? I worked that out by using a USB microscope to see the number stamped on the component and found out it was a version of the 2n3904.? I have some spare 2n3904s and might give it a