开云体育

Buy a few pieces of cheap test equipment. A dummy load. Cheapo watt meter/vswr meter and RF probe. If you can’t afford this get someone to fix it for you, before you do need a new board, Alight bulb

That looks sweet! Roy WA0YMH wrote:

Nice! 73 Bill WA8VIH/4

I'm glad I got my order in already, then! The feeding frenzy commenceth, and I would hie me hence lest I be nibbled! *grin* Having options is a Good Thing(tm).

Best Regards, Stein-Roar Brobakken post@... LB3RE K3RAG Skype: lb3re.rag

Absolutely right about using a new plan and your’s and other’s suggestions! Have to think through the new heat sink . . Maybe leave wspr to qrp labs qcx for now; purposely built for that. I have a

Raj, VU2ZAP: here are the voltages you asked for.

The simpson requires a 30 volt battery that is generally not available, expensive when found. I have 10 3 volt cells in mine, so consider that expense. The voltage and current work fine without it but

A great multimeter designed by Simpson in 1960s. I had a chance to buy two of them for telecom training center's needs in India.

I replied privately to Bruce on this question.? The differences are somewhat numerous, but you can to to my website - www.w0eb.com ( http://www.w0eb.com ) and under the link "W0EB/W2CTX uBITX

Picked it up over a year ago on Amazon no recognizable name. I'd get two more save for I've not seen another. That a RPI-3b will run on a 6AH 5V "charger" for at least 6 hours and still going before I

I would prefer to use unregulated 12 or 13.5V for back lit by cutting it from 5V regulated and manage to change the series resistor to maintain needed current. Regards MVS Sarma

Your mic doesn't require a fancy case.? Here's mine, built with wood and plastic scrap and a few parts I had in my shop.? It works just fine. -- Jon Titus, KZ1G Herriman, UT USA

If it is putting out and you are not getting contacts, you may be over driving the audio going from the computer to the ubitx.. You may not be set up correctly in the software. Make sure your computer

If you are using WSJT-X for WSPR there is a tx% setting.? At 100% it sends every time cycle, lower less.? I still wouldn't tx WSPR without a plan to remove the heat but a lower tx% will also give

I now replaced the output amp with a MCP6284 that I had laying in the shack. That works.? No distortion. I tapped the signal from the collector of Q71 via an electrolytic cap. This strengthens my

It never crossed my mind because I made wrong assumptioms..? ?I have qrp?lab's qrx?on 30 meters that runs 24/7, every 30 minutes on wspr. That runs on bs170.? I'm learning.? Sent via the Samsung

Typo: you have to solder a 4.7K without the resistor it will start keying the transmitter as you described.

lol. Of course.? The VOM should be built into the radio! With the JackAl board ADC/DAC audio capabilities, it could talk to you.? Audio Voltmeter ?( https://youtu.be/Q-VMNEvx4PE ) Arduino demo.

I used a Sunil case with a separate board where all the jacks and the 4.7k resistor are. So I will apply your advice. Thank you again for this valuable info. 73 QRO from Gilles F1BFU 2018-06-16 13:09