开云体育

ARE YOU KIDDING ME -- IT FITS ! That is what this whole discussion is about - it doesn't fit. rOn

Simple solution. Download the original firmware, modify it and load it onto your Raduino. Noone ever said you'd be stuck with the CEC firmware if it came as stock. Vince.

The LM78L09 and LM7809 have very different pinouts and if it smoked on power up it was wired wrong. I cannot imagine a case where the VFO used more power than a 78L09 could handle. Allison

The nano is the atmega168 or 328P(more often these days) what you get. Its the middle child of the set: ? 32k of program space ? 2k of ram space ? 1k eeprom space. Compared to cpus of my day that

Hi Vince, All you need is two 6-lead ribbon cables. 4 pins are not used, just check the schematics. 73, Frank PA7F

Two 8-pin molex will work but you have to shave just a tiny bit of plastic off to make them fit end-to-end. See attached using CAT5. 73, Pat AA4PG http://www.cahabatechnology.com/aa4pg.html

Thank you for your reply.. I finally decided to change the LM78L09 with LM7809.. I think it was because the LM78L09 couldn't take the high current.

Would the BFO frequency shift the filter peak into the 750HZ? range? I have an audio spectrum analyzer app on my android that uses the mic. sure would be something to investigate. I have a source of

Anyone have a link to a single row 16pin connector for make it yourself Ribbon cable? Vince n2aie

Ashhar, I think it should be the standard.? It fits, and no issues installing. more Plus than Minus. 1.? Download and run the Memory manager.? Provides user a different look at what is getting

Good morning, Though not specifically uBitx related, the RTTY timing issues has been discussed ad naseum on the RTTY group which has recently rehomed to (RTTY) groups.io and IIRC the issues with

Back in the 70's, some CB radio manufacturers used a diode in series with the power and it worked well. A couple brands used a bridge rectifier setup in the input power that way it didn't matter which

Tim I disagree. For example, if the standard code has an iambic keyer but I have run out of flash trying to implement an SWR indicator, then it would be handy to free up the flash used by the keyer by

With all respect, do you understand Ian's code well enough to add functionality to it? Or is it just better from an operational standpoint? tim ab0wr docame12@... wrote:

It was 1967-68.. Detroit when I started college, President of K8EEH Henry Ford College ARC.. Somewhere in Detroit there was a Marine, that had been hit while on the Korean DMZ and was paralyzed- lost

Hi Richard, If you mean a second LCD or maybe a little OLED, yes, It can be done ( I did ) but you need to write it in to the software and include whatever library that you would need for an OLED for

Jack, Respectfully, you missed my point. I probably wasn't clear. I didn't mean a "coding" standard. I meant a standard software load with defined functionality. Trying to add functionality that

Tim, and all, Let me preface this with a statement of gratitude to Farhan for supplying such a useful, functional, and affordable rig to all. It has enabled many to get into ham radio who would

Do you mean a 4-line lcd display? If so you have to have a software load set up to use a 4-line display. Have you checked to see if that is the case for your software? tim ab0wr "Richard E Neese"

That's an easy one. If it's your software then *you* are charged with doing the troubleshooting.