开云体育

HI Ian,? Please do use/modify/correct anything that I post here in any manner that you wish.? ? -- Dave Beal AE6RQ

Thanks Jerry, Guess I'll grit my teeth and see if I can solder SMT parts OK.? I've done a few repairs (scariest was replacing a good sized SMT resistor in my Elecraft KPA500 amp) but never an entire

Sorry for you. Pity this happens. It's like when they copy equipment designs without even acknowledging the designer. Regards Lawrence jjpurdum@...> wrote:

Kees is kitting up with surface mount parts only. He will post to the forum with instructions when he has determined pricing and is ready to take orders. Posting here just gives Kees an idea of how

Thanks, Craig. Again, really enjoyed speaking to your group...fun trip! Jack, W8TEE

Hello Ian, Thank you for your replay, I am not using the firmware yet as my ubitx did not arrived, hopefully will arrive in the next 2 weeks. Anyway the ubitx will be used by me only as development

I'll take one of each SMT kit, please! Thank you so much for all the effort! Noel, W1NCR

Buy. Read and Enjoy. Repeat. Buy more, and give copies to your friends! Buy responsibly, leaving sufficient funds for beer. If anyone cares, I usually buy both paper and Kindle versions and use

Dave—that’s perfect! Again, thanks and 73 John From JKL's iPad

I have an old solid state rig by swan and have studied the schematic carefully. I've found that it has an internal bridge at output of the 200 watt broadband solid state amplifier it uses which is

Radu. Tahnks for using CEC Firmware. please wait 2 days. :) If you want to try it now, you can enter the voltage on the only remaining A7 Line. I am modifying uBITX Manager to make all types of

I should have said I want one each of the through hole kits, not the SMT! 73, Bill NZ0T P.S.? will there be a notification of a formal ordering link or does posting here constitute an order?

I would like two of each also. Thanks. Joel N6ALT

I ordered mine a couple months ago.? Just arrived this week.? Jay N3QPW

Hi Gary I will take 1 of each kit please and it can be shipped to Canada or my office in Texas. Mike va3mw

Hi John, I'm back! Loaded Arduino IDE on Ubuntu, but can't make it run. Been trying all afternoon. Hlelp! Regards Geoff

For me one of each too please. John KG5WJQ

Hello, Please let me know on what pin of the nano should i connect the s-meter input in order to use this functionality together with?KD8CEC?firmware. I want to make the same mods on my ubitx. Thank

My solution was to get the 3d printed panels, use the leads full length and order a handful of the jacks since they melt when soldered twice. ? My 'mess' was up and running in an hour!

/g/BITX20/topic/sunils_cases/18132270 /g/BITX20/topic/amateur_radio_kit_metal/18131450