开云体育

HI Jay and thanks very much for your suggestions. For the benefit of others, here is what I did. At our Hackspace night, we loaded 1.07 by KD8CDC. Read this

Hi Jhhn, Yes, large increase in white noise on connection of my 40m dipole. Geoff

Thanks, Ian, you are right, the cortex m3 is a small processor unit, and no DSP extension like the f4, the main reason was the price of midules, I got one module for less than 2 dollars, and the

It is a possibility but is more difficult to obtain good results results of FM demodulation @10.7Mhz. Anyway I will try to demodulate FM directly @12Mhz. Instead of the?FM demodulator coil I can try

Hi Skip, No sir everything is stock. I have only used 40 and and 80meters.? Have not noticed much else wrong, If it is not broke, don't fix it. I have worked 40 states and Ontario with it and my

Callin CQ, Re:? Me too on uBitx delivery, Ordered April 1, 2018, just heard from PayPal 20 minutes ago.? In transit with DHL. 73 RON H., KF3E aka CHOCTAW MARINE

Ordered mine on 4/20 nothing yet but sounds like it might be getting a bit closer. Dennis - VE1XT

Has anybody have the experience of the BITX 40 [no mods yet made] deciding to go into calibration mode on its own? If so how did you fix it? Menashe 4Z1NT

I am not familiar with UK rules, but it looks like the uBitX makes an ideal Foundation Class radio from the specs and the description you sent. 73, =Vic=

Ordered mine 26/03 no word of it been shipped

Hi Geoff, I agree. Hmm puzzling, unless the analogue input have all died suddenly. A bit strange. Ok, A4 and A5 are the I2C lines, when you connect an antenna to the rig, do you get extra noise

HF Signals is getting faster!? Ordered a uBITX on April 03, got shipping notice via PayPal with a DHL tracking# 5 minutes ago - 4/25/2018.? Should arrive in KS in about 4 days if DHL runs like

Giuseppe Thank you for sharing wonderful project. I did not even try because stm32f103 does not have fpu and dac. (Compilation is the same, but FIR and IIR are implemented internally as software) But

Hi, I shared a project of an economic and simple dsp, it is based on the processor arm cortex stm32f103 whose module is at a cost less than two dollars in online shop. I implemented two narrow cw

Hi John, Current consumption is a constant 160 mA, so it is not in 'Transmit'. Tx current was about 460 mA. Geoff

Hello Geoff, With no key pressed on the CW input your voltage is logical. But earlier on you mentioned 1Volt on the PTT and that is not normal. If your Raduino was to see a low PTT logic it would

Hi All, As of KD8CEC firmware v 1.072 and later, I2C LCD? displays are supported. See the firmware manual for how to edit ubitx.h to select the display type. Rod KM6SN

Hi John, The 4.7k has 5v on one end and slightly less on the other. I will isolate the encoder and try again. Geoff

Hi Geoff, I just realised that you can't use the push button either so you won;t be able to access the voltage monitor, so forget the last point about the other software. One think I find strange is

Hello Geoff, So I would say the 5V is fine, your Arduino is working as what is on the display is coherent and at least a set of digital output are working (as they drive the display). From what you