开云体育

Correction. PTT does nothing but the encoder button only exits the menu. The change to CW tone does not take. Regards Simon VK3ELH

If it's at 5000, I'll never hear it. That stupid time station is way too loud. I have tried it though with the plugs still in....only unplugging it from the LCD so I could raise it up. Still didn't

See picture for paddle wiring. Dot to ring dah to tip. With code changes could be used for a straight key also assuming it has a mono plug. Read A6 at start up. If 5v run paddle code. If 1.6v run

A dipole. Not going to change anything on it though. Not going to risk my HF rig over it. But, if I can hear the frequencies when we force it to a frequency, I should be able to hear it when it's

actually, that pic shows 5 caps and 2 resistors. I suugest that it would be useful in these posts if you refer to components by their numbers on the pcb, for example C1, C6 or C5 for those closest to

Caps look fine to me. The two resistors can't really be seen from the at view, as far as the solder joins closest to the Si5153 are concerned but I would suspect that they are also OK.

When you have the raduino out of the case, is the display no longer connected? If you have it connected and tune to a freq, then disconnect it that freq is lost unless the tuning pot is coming with

I noticed mine got here fast, thank you Ash. Joel N6ALT

Nothing obviously awry there.

I can't tell which frequency is displayed, but I have tuned it to a frequency, taken it out, hooked it up to USB and then tried to find it. I did 12,000 - displayed frequency. Never found it. ? I

There was some trouble at dhl bangalore, it has been resolved. Await the shipment details soon. - f

Our local post office refused to handle so many orders, so the gang decided to post all the usa ones through dhl anyway so you guys can get them all before christmas. We didnt do that for europe

Oh, I thought you uploaded another one. The capacitor looks ok but that doesn't mean the connection is good. Load one of the working sketches then put the raduino back in the case like you did to

I included a pic of the sis chip a couple of replies back... right before you asked about just plugging it into usb and computer

what pic? Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/ http://www.metalworkingfun.com

There is a small preset between the two predrivers that maybe used for this purpose. - f

Do those two capacitors look bad to you? I didn't notice that before, but where the solder should be looks cratered in that pic

The USB will not fit into the case attached. I have to do the sketch, remove the USB, then plug the raduino into the LCD.

How about if you unplug everything but the USB and computer? What does it say then? Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

Here is the picture of the Sis chip