开云体育

I just want to confirm that version 3 works.? It functions the same as previous versions, but draws LM386 pin 1 down to ground rather than up to 12V, due to concerns about current in the LM386.? I

A Paypal transaction is not considered complete until the money is in the recipient's paypal account. If your bank is delaying the transfer then the transaction is not yet complete. Vince. --

Thank you for all the answers. I will try to contact Farhan directly.? 73 SP5DRS

On my last order on 8/6/17 the only confirmation I got was from paypal. I think that was true on the previous order as well. You are probably good. 73, Pat AA4PG Pat

In that case I would first check the spam / junk folder to see if it was misfiled. Otherwise contact Farhan directly to see what might have happened during the purchase process. 73 VA3SFA

The problem is I do not have PayPal account (you can pay using credit card without it). I'm sure the transaction is completed because my bank account has been charged. What I am not sure is if the

I'm not responsible for this but having purchased one earlier, I did get an email confirmation. I would suggest that you login to your PayPal account and see if the transaction completed. 73 Faisal

Hey, Is it normal that I did not get any email confirmation after I paid for BitX via PayPal? It seems that the only proof that I order anything is the record on my bank account. Any person

Good looking mic. Now you just need one of them foam balls on the end of it. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

Hi David, Looks like you have a "picky" DDS chip. Cheers, Will

Ashhar Just a few thoughts on Dexter's wire length suggestion. ? A simple manufacturing jig is one way around this, one for each Toroid?version with a different number of turns. ?In basic terms,

Yes, Replacing Q13 did fix the problem. But, many thanks for the correct Q13 type. I simply used what was on the schematic. Another great thing about this list! 73, Pat AA4PG Pat

Hi Jack et al I have already tried adding a delay to startup, I started at 200ms and went to 2sec with no success, I have already added the 2 calls to send frequency like this. ? ?

It took me half the night to get the article done, but here it is. Make your BITX40 work on 40 and 20m using QRP Labs filters and a bit of soldering. Feel free to poke holes in it, or ask any

I want one ;-) MAc sp9mrn

That would make sense. David is just unlucky in having a particularly screwed up chip when it starts. I recall a particular bit of gear at work, on one unit a particular set of plugin PCBs would

I see now, it's a new symptom description of an overloaded, or something, Q13. Right? I first read it as a question. Well... good on ya then.? But once I did hear with a receiver while the final had

I have found that the key word to use in a search for information on a particular board or component is "datasheet"; for example "AD9850 datasheet". That usually produces a much larger set of useful

Don't you enjoy the facial expression of the clerk in the plumbing department as you try to explain you are working on a microphone. I think this will do just fine. I may leave the plumbing in its

We use an AD9850 and it's been used as a straight VFO 160-10M in the Arduino Projects book, so I think it would work fine. What I suggested does not involve any hardware at all. Simply a new state