Good looking mic. Now you just need one of them foam balls on the end of it.
Vince.
toggle quoted message
Show quoted text
Don't you enjoy the facial expression of the clerk in the plumbing
department as you try to explain you are working on a microphone. I think
this will do just fine. I may leave the plumbing in its original color and
markings just for a conversation starter.
As you can see in the back ground, I finally got brave enough to cut on
that rectangle. A little touch up with a file is still needed. Here is a
closer picture.
Getting ready to drill the hole for the volume control. Rather than use
the pot for the volume control, I was thinking about using the tuning pot
for the volume since the shaft matches the size knobs I have. I suppose
the only difference is audio taper vs linear taper?
--
Michigan VHF Corp.
