开云体育

Nope but then I don't get a pop when I key up I have the c124 mod done I used 6.8yf it was all I had [email protected]> wrote:

Does the agc reduce the push to talk pop?

I also recommend a pushbutton for SPOT/FINETUNE. 73 Allard PE1NWL

Hi Mike, I used DBM on HP test set. The output was by ear. Minimum discernable signal. Volume full! This was not a Two tone ssb test. Do a minimum discernable test, thats a level you can have a

Hi I built vk3ye's audio AGC and it works well on? My bitx. there's one change on the video that's not shown. on the circuit the resistor between in4148? And base bc548 is shown as 4,7k ohm but on

Can you describe the procedure you used? dBm or uV? Did you use an output signal somewhere to monitor with scope? With SSB, how did you set up the modulation? How did you determine you were not

Errr, function button, not mode button. Sent from Mike's iPad WA1MAD

Well, I believe it finally uploaded successfully after a few Win 10 usb port hiccups. Now I need to add the mode switch and the wire up directions and probably remove/disable the anti gallop buttons

Thank you for your answer. I think I will keep it connected. I wanted to switch in order to check the difference of having it or not. Would this AGC eliminate the birdie sound? I feel it barely

Hi All: Thanks to everyone who responded , the LCD VFO items listed have been sold. Thanks and 73, Ross K7RSB

Hide San, I was just as surprised! I had the volume cranked to full to hear it. When I connected the antenna back the volume of noise was deafening ! The amp capacitor C113 is connected. Monssons

Hello Allard, OK I understand your suggestion all. I'm looking forward the next firmware update but take your time plaese... Thanks again,73. ja9mat Hidehiko.

Hi Hidehiko-san, Sorry, but that will not solve the issue unfortunately. In the current design, the radio will automatically return to SSB mode when the PTT switch is pressed. Perhaps we need

Hello Raj, Really -130dBm? It's great! I will try again but I think I'm not able to hear -130dBm with my HP SG. ja9mat

Good news for me! managed to fix my function Seimens generator. One white power bypass smd cap had a neat hole in it! I connected the sig gen and found that I can hear the signal down to -130dbm.

Hi Allard, Thanks for reply and OK I understand all you mentioned. The first code loss will be prevent by using the manual PTT SW to ON. But I feel the main issue is the 1:3 ratio of the morse code

Hi Hidehako-san, The cause of this is that there is a burst of RF which is coming directly through the balanced mixer which is unbalanced for about 60 mS due to the microphone amplifier stage being

OK thanks sarma and Raj, Yes, -117dBm is enough for me.! I only want to know the limitation of this simple receiver's sensitivity. I'm waiting for Raj's measurement result. ja9mat Hidehiko.

Hi Allard, Thanks for your reply quickly. Well I feel the delay is noticed when I start to key the first dot or dash is lost. And I feel the 1:3 ratio is broken during the transmit. Especially the

Thats about 0.3uV, more than enough. On 40M the atmospheric background noise is higher than this. You need a K2 sensitivity when using a poor antenna like a mobile one whose gain will be negative