开云体育

Steve, I received my zBitx yesterday and CW works surprisingly well, considering all comments of the last few weeks. At least, when selecting Iambic. I can’t handle Iambic B, but maybe that’s my

Done

Are there any updates on when the V4 will be available?

https://wiki.debian.org/DateTime 73 Andy

Dave, Are you seeing the desktop environment when you connect the radio to a HDMI display? If not, could you reflash the SD card ( https://www.sbitx.net/index.php/creating-a-backup-microsd-card-image/

Hi Dave, what powersupply do you use ? 18650 battery’s or external powersupply ? i had some cheap 18650 battery’s from HAM flea market….fully charged but within few minutes they draw empty (low

For more space try using the NANO Every Ron

I just received my zBitx, and have read the manual as well as been following this group for the past couple months. I hope to use this rig primarily on CW and perhaps a little FT8. I am aware of some

Rick, You did something differently than you should have. Everything is set up in the 64-bit OS Image and such a problem is out of the question. So could you tell me what you did to get a 64-bit OS?

Hello. I'd like to make sure there is no confusion about the N8ME firmware. I was not involved with the development of the N8ME firmware in any way. I am only a guy who added a day/night mode feature,

How do I update the boot up image. my raspberry pi showed the correct time. Can somebody help. DU1ZC

Thanks Joel -- [email protected]> wrote:

Rick, I took a old USB cable and chopped off the end that would plug into the computer, I then wired the 5V pair out of the cable directly to my 5V source, then plug the other end into the Raspberry

Just got my zBitx today.? Powered up, and the nice screen pops right up.? It says "Waiting for the zBitx to start..." and no other response.? Been waiting a long time, but no joy.? Tried power

Hi Joel -- it has the upgraded regulator installed, the replaces the LM338 R [email protected]> wrote:

Rick, Did you add a different 5V regulator like a Drok or similar? If so, you can fix the low voltage problem with a old micro USB cable. Let me know and I'll explain how to to do it. Joel N6ALT

Hi to the group, I finally got my Sbitx DE up to 4.2 and it works fine but I have two issue 1). Low Voltage power warning when the PS is 14.1 Vdc 2). The display is about 1/2 the brightness it was on

OK, I updated to the 64bit version, but now I have a low display brightness and a continual low voltage warning. Changed PS but did not make a difference. Suggestions? Thanks -- Rick wrote:

Same here. Firmware version 1.06. Received my zBitx today, so I might need to upgrade. CW works pretty good BTW, I set delay to 500 and sending 20 – 28WPM is no problem using IAMBIC A. But SPLIT is

#3753 shipped this morning.? April 1 order date.? Pretty close to 4 weeks.? Island time. --CG AH6BI