开云体育

Uploaded fine ... but shows up as v1.04

USB-C with PD are a better solution as they are less likely to be producing noise. However, you should note that the power bank has to be big enough to provide 3 A @ 9V.

Hello Ragav, Thank you for preparing the new manual. For document control purposes, PLEASE place a Revision Number such as V1.0 and a DATE, such as March 30, 2025, on each issue and keep that

-- Glen, WB4KTF, Austin, TX

Try this https://github.com/afarhan/zbitxfrontpanel/blob/main/zbitx_front_panel_sw.ino.uf2 [email protected]> wrote:

Couldn't download zbitx_front_panel_sw.ino.uf2 from HFSIGNALS page. Downloaded code from zBitx page.- zbitx_front_panel_sw.ino.uf2 dated 3/30 9:15 AM. Xfer to zBitx - no response (stays on gray

Yes, drive is set to 100 and I am using the native application. The voltage coming off the barrel connector of the included battery holder is 7.56(display shows +7.4v) with 2 brand new fully charged

Seems like a little work with a volt ohm meter would bring clarity to lots of these situations Gordon kx4z

I watched the video you made. I would try some things. You should know that the USB cable to the CAT connector only powers the screen, not the raspberry pi. Therefore, it will never turn on. I would

Ragav, Yes, I can download now.? Thank you! 73 Evan AC9TU

D'oh! The sharing was restricted earlier, Evan. I've changed it to public now. Can you try it now? 73, Ragav

Ben, Can you confirm that the drive is set to 100? Are you transmitting FT8 from the native application or are you using a third party program like JTDX? Can you please confirm the input voltage and

Hello Ragav, I tried downloading the zBitx manual but was told I did not have access.? Did you intend to restrict access? I did request access through the pop-up web page. 73 Evan AC9TU

Hello folks, The zBitx user manual is available for download on https://www.sbitx.net/index.php/zbitx-user-manual-download/ If you are unable to find what you are looking for, please send us an

Mike, We haven't received your email in our inbox. Can you please resend it to sales at hfsignals dot com and also mark support at hfsignals dot com on CC for good measure. I've raised this issue

Did you copy the contents of the /sbitx/data folder from the 32-bit uSD to the same location on the 64-bit OS? This requires an intermediary USB stick, to which you copy from the 32-bit, and then copy

Is the Zbitx barrel connector 5.5 x 2.1 or 5.5 x 2.5?

They work. The only thing to keep in mind is that it will only deliver a certain amount of watts... I think they claim 3A, which is at 5V 73'

I actually prefer step up rather than step down because worse case senario if there's a short, I'd only be putting 5vdc on the output not 12vdc. The bioenno BPS that I have (discontinued) has 12v and

I got my zBitX this evening. Got it on my wifi to sync the time. I can see ?ft8 decodes. If I TX the sound comes out of the speaker instead of going to the radio. Zero output on a watt meter so no RF