开云体育

How did you contact them? Get Outlook for Android<https://aka.ms/AAb9ysg> ________________________________ Sent: Tuesday, June 11, 2024 2:07:08 PM To: [email protected] <[email protected]> Subject: Re:

I had virtually the same problem. The unit stopped operating after about 20 minutes, with no power out. Then repositioning the box on its back restored partial power, about 18 W on 80 m, dropping to

So let me restate the question how do I diagnose a low power out condition?

It's interesting, isn't it, as long as you don't know what the CPU temperature is, it doesn't bother you. You just use it. Google says: "What is the maximum temperature a CPU can handle? How hot

Here is a sneak peak on another project currently in development. -JJ https://github.com/drexjj

So as long as it's in the grey it's okay. Thanks JJ, I'll stop worrying now or find something else:-) BTW, it seems to be working quite good. I don't know if this is possible, but the waterfall seems

The temp will change from orange to red if the radio gets too hot. It is primarily there to monitor the Pi CPU temp inside the radio but can be used to indicate relative internal temperature inside

I never worried about my sBitx V3 temp until yesterday when I upgraded to JJ's 64 bit OS, now the temp stares at me all day long making me worry. I run my V3 all day everyday. it's been on almost

Thank you Gary, now everything works @5Vcc ( but no more touch screen, of course!) I can probably save energy at 3.3V, but I use the 5351 board from Cina, working @5V. There is always something to

What was left out of the previous message: -- Gyula HA3HZ

Bob, On my 64-bit RC1, jtdx works with the following settings: see message #110915 ( /g/BITX20/message/110915 ). -- Gyula HA3HZ

I have a unit I purchased at Hamvention that is only putting out 9 watts. I sent and email to the sales email address about the issue but no response. This group is great but this is an OEM issue I

Tom Try the screen resizer in the sBITX toolbox to give you a larger virtual screen that you can scroll around in. -- 73 Bob? KD8CGH

Thanks for the reply Gyula. I tried USB, DIGITAL and FT8 modes with 127.0.0.1 and? 127.0.0.1:4532 and none of them worked. -- 73 Bob? KD8CGH

Thank you very much for the memory card and note? that fixed it it's up and running great I am sending you a new one out

This group continues to amaze me. Everyone is very helpful and, even better, they have great ideas and solutions. I expect the cable tomorrow. 73, Bruce, W4BRU

I would like to use WSJT-X but can’t figure out how to adjust the screen size to allow accessing the fields at the bottom of the parameter page. --Tom WW8LA

Raspberry Pi foundation broke their 6.6 kernel DSI display support in some versions (around 6.6.20 to 6.6.30). Latest upgrade to 6.6.31 fixed the issue. I'm following the issue in their kernel github

Bob, what mode is the radio in?? Try it in USB or Digital mode. -- Gyula HA3HZ

You could wrap the cable around some ferrite rod? and see. Raj