开云体育

When I typed my previous message, I did before I typed in SBITX A /UTC 2024 03 21 Some time, but no change. I think the funds have to look for the cause. I remember when the de de appeared, the RTC

Try this.. Open sbitx and type this in the text box.. *\utc 2023 05 01 05:00:00* the sbitx display time should change.. then close sbitx and reopen it to see if it is synced to the proper time..

No change with using "pool 0.pool.ntp.org iburst" etc, I even tried the local for me "pool 0.au.pool.ntp.org iburst". But the time sync does not seem to be the issue. My sbitx is "V3 complete kit

Hi every one.. Does any one halve a correct schematic for the v6. I am looking at the on board relays whitch are all the same configuration. They are 8 pin dpdt type Hongfa 27 /012S . all of the

Try changing this in */etc/ntpsec/ntp.conf* : pool 0.debian.pool.ntp.org iburst pool 1.debian.pool.ntp.org iburst pool 2.debian.pool.ntp.org iburst pool 3.debian.pool.ntp.org iburst to: pool

JJ, are you on "Daylight Saving Time"? Melbourne Australia is still on AEDT (+11:00 UTC), and will change back to +10:00 UTC in a couple of weeks, so maybe the sbitx program is not picking that up

I got the basic sBITX which didn't come with an enclosure so I have been happily operating my sBITX for a few months and never knew that there was a problem with the encoder board. I did not notice it

Darn! 1 De & 1 v3, that leaves me with a pair. ? 73, Robert AG6LK

1 hour difference? Here is is my screen on the beta2 build. I am currently -5 UTC which is correct. Th is so strange.

I am looking at the macros in cw mode. It appears I am missing some of them F3, F4 disappeared until I hit F5. I suspect I need to change screen size perhaps? Any idea?

Same issue here JJ with your 64bit v2, and the terminal shows the ZULU correct, very strange ... -- Pete VK3PYE

Are you running my build or another build? If not my build, then I have no idea how to help other than these commands to see what is going on.. *ntpstat* *ntpmon* Also run *./sbitx* from the command

These are all acceptable and reasonable workarounds.. My v3 is a little over a month old and it came filled with some sort of dust or ash, a Faulty AF circuit, and the encoder board debacle. Not to

One. Someone could create a new printed circuit board that puts the connector on the opposite side and properly deals with all the wires Or Two. Remove the existing encoders, probably destroying

I fully agree with you. The execution of the encoder board is pure stupidity. <andreas.schreiner@...> wrote:

Second image does not like rotating, so here it is again:

I just got my sBitx and the screen was a bit loose/something rattling inside. So I opened the case and found some loose screws (immediately fixed) and the same problem with the encoder board. Before I

I don't use a VPN, the Internet only works through a direct ADSL connection. I also indicated in the previous image that I have three types of time. The first time I select the time zone, EU Budapest

Adam, There is no configuration setting for the encoder.? I suspect it is a detent encoder.? Those seem to have issues when the pulse is on a detent.? Look for an encoder without detent in the 12

Evan, I bought a second-hand radio equipped with a Nextion display and do not know what firmware was loaded. I loaded the KD8CEC firmware but did not know how to use the setup function. Thanks to