开云体育

Hi Dean, It's a clever solution and you're making good progress. If you have time, don't forget to update sbitx too, because sometimes the LOG save won't work. v3.02 can already be used quite well in

and Vic wins the internet for the day! Thank you so much - check out video - transmitting and have power out now! 2-3 Watts with a whistle. https://youtu.be/DJ7eihsmf5c?si=okcjlyanThRmGRwi New

Solid state is the way to go if you want full break-in, especially with CW.? Don't know if you need the fast T/R changeover for FT8.? I haven't actually had a chance to use mine yet.? If you use

Latest update - I built a three stage PA - 2n3904, 2N2219A and RD06HHF (patterened after the BITX40 schematic).? I plan to build an RD16 push-pull final for ~20 watts across HF.? ?The next step was

Just curious if it's a Pi problem, but I attached my 30 foot OCF dipole that works great with my yaesu Dx10. I cant even receive with this radio. Im curious if there's something I missed as far as a

Well, that didn’t work. My keyboard just doesn’t work

Thanks Dean for your reply. Vu2spf

Gordon, I hope you find the source of this. I have scoped various points and think it has something to do with the CODEC. I have not been able to pin point the source at these low levels of amplitude.

Sounds good Gordon. My focus now is the RX audio to reduce the high level of noise that exists even without a signal as well as addressing the low level of audio output on receive. Paul

Does compressor (just add a simple fast AGC to the mic input) make sbitx sounds better? I was thinking and adding it to my sbitx software. - Rafael

Paul -- the "bassey" problem is EXACTLY what I have three high school students (AP PreCalculus) working on as a Science Fair project.? ?I have added command line code

The *LICW Refrigerator Magnet* is printed on flat magnetic material, the very same magnetic sheet stock that is used for all those useful calendar magnets sent by your favorite insurance companies.

I have created a new WIKI page with the schematic, parts information and article See the MODS page: /g/BITX20/wiki/30734 Gordon KX4Z

Hello kg8jk, The KD8CEC software has a separate BFO (carrier) setting accessible through the Memory Manager software.? The original KD8CEC manager software only runs on Windows.? It is here:

It certainly made a difference for me, with the new insert I have mic gain set at 27 now which seemed about right for my voice which is quite bassey to start with. Probably need to find a way to

Paul, Thanks for the tip about the -24dB sensitivity microphone. I looked at many links, and finally found pieces available for me at Reichelt(de). Until now, it only had a sensitivity of -35 dB,

Thanks Gordon, that worked ok

Hello JJ and Gyula Thank you for your response to my query. It was a server problem at GitHub. It cured automatically after some time. 73 Have a great day Ameer Khan VU3SQM

Odd. Try this one: https://www.nf4rc.club/how-to-docs/bitx-resources/homebrew-microphone/ Gordon Kx4z

Hello, Just updated to the nextion display and am super excited by how well it works compared to the stock display/firmware. The ssb sounds amazing but when I switch to CW the audio sounds (as best as