开云体育

Ash Har, Did you try it on ft8 on DE. After transmitting, it would go back to receive properly. -- Bob AA4FJ

Hello everyone! I’m trying to use uBitx firmware for another rig restoration, and I’m having issues with the CW mode… long story short: How can I disable TX line during CW and just get the

In the pull down Mode selection, We see "Digital". What is the purpose for this mode? Does it use the internal sound card, Or what are the benefits? Thank you Nir

Being software defined, it can transmit anywhere upto 30 MHz with single line changes in the hw_settings.ini. However, the LPFs will not have sufficient attenuation of harmonics. I would recommend an

Looks like the radio can transmit on 5Mhz. Can we? Or it is not recommended? Thanks Nir? 4X1FK

Bryce, I guess I was unclear on the instructions when using a signal generator.? You should not have any modulation, just a pure sine wave carrier.? To use the 1kHz offset, you set the generator

Good news!! Thanks Joe (VE1BWV)

HF Signals had stopped shipping for the last ten days pending this update. Yesterday, I tested out the update on developers edition too and the spike is gone there as well. - f

Hi, Just uploaded an instructional video on how -- if you have a spare Nano 3.0 -- you can try CDC V2 beta without risking your existing setup. Basically, you can install V2 on the second Nano and

Bryce, Just uploaded an instructional video on how -- if you have a spare Nano 3.0 -- you can try CDC V2 beta without risking your existing sertup. Basically, you can isntall V2 on the second Nano

Yellow toroids are usually powdered iron, not ferrite, and specifically mix #6. The toroids in the upgrade kit are not 1/2 inch; they are smaller; the wire on them makes it hard to get an accurate

Shirley, Those are 1/2 inch toroids, so FT-50 and I believe yellow is mix 43, which is good for LPF in the HF range, so FT-50-43 Can someone confirm this? Jack, N6LN

Thanks for all your work. Just ordered an SBITX yesterday, hope it gets the latest software version. Looking for to play with the new rig. Joe VE1BWV

Thanks for sharing. Just ordered a Sbitx, saw your stl's and printed a PLA silver silk version while waiting for the rig! Joe VE1BWV

I managed to drop one of those two yellow inductors in the process of finally upgrading my rig, and it skittered to places unknown. I would like the specs of it so I can replace it.

Cheers Evan.

Evan, Thanks for your reply! I believe I can accurately measure the tuning error via the CW transmit method.? Sounds like maybe the easiest thing to do is to turn on RX shift (TX shift off) and

Hi Bryce, Congratulations on a working radio! Rather than play with the tuning, now that you have a working radio, I would use the Memory Manager to try to get as close as possible to a known

Thanks Evan! I followed your advice last night and created wire antennas for the function generator and radio.? I then tuned to the zero beat frequency.? I had updated to v1.2 of KD8CEC code and

good work!