Bryce,
I guess I was unclear on the instructions when using a signal generator.? You should not have any modulation, just a pure sine wave carrier.? To use the 1kHz offset, you set the generator for 1kHz above or below the target frequency.? You can then measure the audio tone frequency to see how far off the dial is from the generator.? It would be the difference between 1kHz and the measured frequency.
The calibration is much easier if there is no modulation on the generator signal.
I should also note that the measurements must be done in SSB mode, NOT CW, due to the potential CW offset on receive.
73
Evan
AC9TU
