开云体育

When connected the net the OS time updates itself. When disconnected from the net then only sBitx keeps it clock updated. That should be OK!

My V2 does displays proper UTC time when running sbitx but the pi os never updates the os time whennot running sbitx software. Ron

1aegisfc, UTC is the time you want.

Is the utc showing correctly on the sbitx software? That is how the sbitx works. It doesnt set or reset the opersting system time. - f

Did you put a coin cell in the holder? It doesn't come with the radio because of shipping restrictions; you have to buy it locally. (If you upgraded a DE you also have to install the RTC module.)

My sbitx pi is not maintaining time when powered off and not connected to the internet but utc is correct. Please advise

Hi Bryce, My first point is that you must be careful when connecting the USB cable to the Nano.? The regulator on the Nano will attempt to power the circuits on the Raduino board and back feed

That's one gorgeous setup.? Wish I had the room, the skill, and the budget. Gerry Sherman Sent by the Windows 11 Thunderbird

1. Are you able to hear anything? Noise, even? You might try tuning a local AM station. 2. Assuming you have an oscilloscope, do the clock generator frequencies match the frequencies you expect? In

Did you do your scope work on the main board or radunio? ?Check that the Radunio board is properly fitted to the main board, I.e. not offset by one pin. Not at my computer where I can check

Hello All! TL;DR: Long story short, I seem to have blown up the original Nano and need to replace it.? ?The destroyed Nano may have taken out other things. For a little background, I'm an EE with

I need an L-shaped desk like that. Right now I have a plastic picnic table for a desk. It is too big but not enough usable space if you know what I mean. -- '72 Aaron K5ATG

That is awesome -- '72 Aaron K5ATG

This noise is radiated from the I2C bus during the frequency change. Increasing pullup resistors may help. When I opened up PL-880 and tried to hook up to the I2C bus to sniff, I've found that the

If you like to work with wood, you can draw inspiration from this to make your station *dt

lo, cSi vous aimez travailler le bois, vous pouvez vous en inspirer pour réaliser votre stationLildt

I noticed that the sbitx tends to pick up local noise if you leave the antenna port open. Either connect it to a remote antenna (not a whip antenna connected directly to the sbitx) or a dummy

Hi Dave, It sounds more synthesizer noise, It's really noticeable if I disconnect the antenna and then tune across the band and it's most prevalent on the higher frequency bands like 20 meters and

Aaron - I'm not a woodworker.? What you might want to consider for the top is to use a veneer which is a totally different colour than the wood underneath it, and do some carving with a router for

Sure thing, I will probably come to this thread often to ask for the opinions of the members of this great group on different ideas. For example, the part of me that enjoys working on the scroll saw