开云体育

Once you get it built and have used it for a while, report back and let us know what the performance is like. Thinking about getting one. Max KG4PID

I just receive Sunil's Easy Bitx kit in the mail today.? It exceeds my expectations.? The kitting and packaging alone is worth the cost of the kit.? Sunil has a great manual on his site and the

Farhan, I hope that you are working on new version of software only / refactoring code …not on new version of hardware platform, hihi. - P

Darrell, We have tested the radio long enough. The best thing about the SDR is that it is all in software. I am already working on the next version, refactoring the code. The boxes will be picked up

Re: sBitx V2 Question About Frequency Readout Display I saw a picture of the new sBitx V2 and the Frequency Display looks really small. Does anyone know what the approximate size of the frequency

Thanks Evan. 3.3v zeners did occur to me, ?Incidentally I did have Zeners across the finals and still one of them shorted. It’s strange. Jack N6LN

John, I have been thinking along the same lines to protect the most expensive component in the sBITX.? Here is what I found in a search on the

Hello Ashhar: I agree with the other gentlemen.? Do not rush and make mistakes.? Instead, take your time.? A good radio is well worth the wait.? And I get to be on the ground floor of Version

Sorry to come back to this topic again, but the pin 5 is not the I2C SDA? This LOW/HIGH changes would not create some noise in the I2C communication? I created a PR removing such

No problem, there are also "off-the-shelf" ones. I'll choose one and test. tks!

I built one with an Arduino nano, a 10uf cap and two resistors. Not sure where I saw the circuit diagram. - f

Thanks Ashhar, there is what I thought. Btw, which "burner" do you use to write the firmware to the ATTiny85? Rafael

A few of you are probably familiar with my experiences with the DE version of the sBitx. There have been quite a number of different things happening which, by Occam’s razor, are in my opinion for

Gerald, Watch the MicroCenter website for Raspberry Pi's if you live near by you may be able to pick one up for a reasonable price. When they get PI's in stock the price is not inflated. A few

I do not want to hijack this topic so I will start a new one. /g/BITX20/message/101161 73 Evan AC9TU

I did a performance test with my sBITX DE running v2 software and could not run the sbitx code and the Chrome interface on the single Raspberry Pi 4.? That was after swapping out the 2G for a 4G RPi

Cheap too (4N25 $0.16 per 100). Jack, W8TEE

I prefer to use an optic isolator. A lot of protection in a small package.? Max?

Ah, a good spot. I wanted to check how fast the adc works. If you see, the pin 5 is being flipped on each iteration of the loop. So, I connected the pin5 to an oscilloscope to measure the time

Rafael, Exposing attin85 pins directly to external lines can be risky. It would be better to tie the tx_line (it goes high on transmit) to a 2n7000 gate and use the drain as an open / close ptt