开云体育

yes that's what I like to know to -- ED W2ELM

Any idea how much the sBitx will cost? Thanks and 73, Michael N4MJR

I had a similar issue with various lengths of coax.? Used a 1:1 unun from LDG - problem solved! -- Mark, kb9woo Milwaukee, WI uBITX v6

Thanks guys, I have ordered some ferrite beads and am using a manual tuner for the ubitx. There is maybe a 10ft coax run to the antenna from the tuner. Going to try with various lengths of coax and

Sounds good Ashhar, I will keep an eye out for the announcement !!

Hi Farhan Living one side sBitx manual, when we can we lay hands on the set what is the fun. Hope ny next Lamakaan meet we get the set in hand Regards Bala

Peter, I am testing the software. Now, it is only bug fixes. Unfortunately I am an old school ham and I have no prior experience with the digital modes. I am writing the manual while using the radio.

Ulf, I agree with the other Dave. If you hear signals with the older arduino, then your rig is definitely not dead. I would say 70% alignment,or software incompatibility,or30% arduino problem. Dont

On one of my problem children like this one, i found that my swr was actually high even though the tuner was indicating otherwise. I built a manual tuner and incorporated an swr circuit into it and

Has anyone else seen any recent details of when the sbitx will be released ?

It is a diode mixer. The kiss leaks carrier

Hi John, The v4, v5, and v6 boards have M3 holes.? I do not have a v3, so can not measure the holes on that board. 73 Evan AC9TU

Yes M3 as I remember - 3mm metric.

Hi Ashar It was fun to see you updating when I was reading the FT8 section :-) When can we see the full schematic of the transceiver? Is the second mixer a? 3157? in the end product or is it a diode

Really nice looking, full-featured, rig! Jack, W8TEE

I have tried some different standoffs but the pc board hole is smaller than what I have (6-32). Are they M3? 73s John N4HNO

I am impatiently waiting for the new schematic!!! Almost ready to start, all components on my table. It will be a great small rtx. Paolo

The manual looks good Ashhar, I guess people will be able to make additional contributions once they start playing with the device, whilst we are on the subject it would be really good if we could get

I had a problem on a well-matched 40m end-fed -half-wave portable antenna. Only on 40m the uBitX radio running CEC software would go into menu mode when transmitting. Adding a 10 ft counterpoise to

Thanks a lot Farhan! Can't wait to put my hands in a sBitx! : ) Cheers, Rafael