开云体育

Right now it looks like the Mini Dummy Load, the Morse Code Tutor, and the 6A power supply will not have PCB's. The circuits just aren't that complex. Jack, W8TEE

Thanks Reed!? I did add that issue on Github as you suggested.? I'll get this figure out some day ....

Excellent Jack. Does the book point out which projects have a PCB available? 73 Ken VA3ABN [email protected]> wrote:

Yes, but you'll have to use different software. There is a port of Ashhar's 5.1 factory code that will work on V5 Raduinos and the V5 ubitx. CW may not work on it though and you will have to leave the

They have not given us a hard publication date, but they have the entire manuscript. They said they have to redo their License Manual material first. We asked if it would be ready for Hamvention and

When is the expected book availability Jack? 73 Ken VA3ABN [email protected]> wrote:

We already have a pre- and post-processor system coming out soon. They are part of the new Projects book that is being published by the ARRL. These are the projects in the new book: Jack, W8TEE

Jim, glad to see CAT is supported (a requirement for me!).? Does this (re-)release of the Teensy 4 adaptor support v5 as well?? I thought from reading the TSW website that the answer is yes, but

Dave, Thanks for the feedback and tutorial. I selected that antenna specifically because of the the no tuner claim. Unfortunately I think your snake oil call is on the money! That’s the bad news.

Mick, An end-fed antenna at it's design frequency (where it is a 1/2 wave say at 7 MHz and thus about 66 feet long) will have a very high impedance at the feed point (one end). You typically can't

Now working thanks Philip

"...be aware that the "Processor" needs to be? ATmega328P (Old Bootloader) with the more recent versions of the IDE" That's not always the case. It's most likely to occur with clones. You should try

I've actually made that mistake.? But then I've made most mistakes. Hahaha. Don Km4udx

In addition, for the Arduino IDE via the GUI, under File-> Preferences set to verbose by Clicking "compilation" box for "Show verbose output during" set "Compiler Warnings" to pull down "ALL". This

Ashhar, I draw .322 on RX and 1.47 Cw and shouting the loudest I can I draw about 1.5 amps at exactly 12 Vdc. I’m running a new MFJ 1984 endfed antenna that is supposed to be tuned at the factory,

Philip, from my limited testing the answer is yes, just like the oringnal uBitx, (FT817. 38400), my checking was done with Ham Radio Delux. Note not all FT817 cat commands are implemented.

Hello Bob. does the firmware do CAT control. Philip

Hello Armando, if it is an amateurradiokits.in then they do have an issue with the V5 board. I had to grind off the bump in the case ?right underneath the board with the headphone connector so it

The Antuino from hfsignals is also well worth considering. It can measure the SWR of an antenna, and with an appropriate resistive attenuator it can measure the power output of a transmitter. Unlike

I remember reading posts that had the same issue.? It was traced to a clearance issue between the aux board and the v5 board.? When installed the 3.5 mm jack terminal was shorting out.? I would