开云体育

Hello Bob. does the firmware do CAT control. Philip

Hello Armando, if it is an amateurradiokits.in then they do have an issue with the V5 board. I had to grind off the bump in the case ?right underneath the board with the headphone connector so it

The Antuino from hfsignals is also well worth considering. It can measure the SWR of an antenna, and with an appropriate resistive attenuator it can measure the power output of a transmitter. Unlike

I remember reading posts that had the same issue.? It was traced to a clearance issue between the aux board and the v5 board.? When installed the 3.5 mm jack terminal was shorting out.? I would

That request would be best served by creating an "issue" here: https://github.com/afarhan/ubitxv6/issues I've noticed that it reverts to default as well, and I agree it might be nicer to show the

In addition to what Jack said (OS, Arduino IDE version, and actual error output), the version of the code you're trying to compile and where you got it from may be helpful too. Reed

It would help us figure it out if you pasted the error here, too, and detailed the IDE number, your Op System, and if you copied all of the files into the same directory. Jack, W8TEE

Anyone know how to overcome the EEPROM.put (CW_KEY_TYPE_temp_key) error that keeps coming up in my ubitxv6 compile? -- Bob NZ2Z

I’m running the basic CEC software (not _S version) using the LM358-based S-meter sensor Ian offered on his site to drive the S-meter function on the Nextion display. To attempt relative power

We need a more objective criterion ti assess what is happening. If the local radio ia picking up the modulation then the mic can't be a suspect. If the receiver is working then there is a negligible

One trick I've used? is to see how hot a 50 ohm resistor gets, Compare that to how hot a resistor on a variable voltage DC supply gets, vary the voltage till the heating is about the same then

Sounds like your speaker is grounded to the chassis on one terminal and your new configuration requires the other side to be grounded or no ground at all but two separate leads. Mo

Oooops!? Correction: obviously the BFO and Freq adjustment numbers are stored.? What I should have said was could they be pulled back in and displayed like the other values that are stored in

Maybe try nylon screws andstandoffs ?via my shoephone Sent from BlueMail ?

Has to be FAT32. Here’s a link to help: https://dashcambros.com/pages/format-memory-card-to-fat32

must the sd card be the fat32 format. it shows formatted as fat. windows seems not to be able to reformat these things. dve k7da

just to throw my own experience in here, I was suspecting the mic was bad too, but I also didn't have a proper low power meter. This morning I found an old power meter with a 10W range and tested

Odd situation. I have a working v4 in a metal case (from https://amateurradiokits.in/ ) It has been working fine for a long time. I had ordered a v5 months ago and finally decided to put it to work. I

Ashhar/Hans hams everywhere are truly blessed to experience fine radios.? all was meant to try to 'redeem' a thread focusing on concerns with the size etc of the uBITX (one can wonder where the term

BUT, can you do things like add a new modulation scheme, like FreeDV or other codecs? It seems that would require SDR-level coding, something that couldn't be easily bolted on at the UI level. Would