开云体育

Just thought, I should have added this picture of a finished board, showing the parts nicely. Dang big picture. > > -- *k*

well, just because I can? ..I know "smart-ass answer", but I bought the ubitx to play with so ...and I don't like the sound with the clk0 running on it on AM Jim

with regards to what?

Also, I forgot, here is the board layout for the board that comes with the kit. I inly have the parts, but will put them on a perfboard. [image: image.png]

Here is the scematic. [image: image.png] -

here is a partial schematic for the BITX40 from amateurradiokits.in. You can see where the AGC ic connected to the first RX IF amp. [image: image.png] I'll look for the schematic for the AGC kit for

Somewhere, in the loft of the garage, above the shack, rests my old HP-65. I lived on ramen and cheap hamburgers for several months, scrimping and saving for that freshman EE major's dream, complete

Are these what you mean by stand offs? 4 are used to mount the main board, and the other 4 to mount the display to the raduion. [image: image.png] Plain and simple.

Been using HIFI Berry + and RTC for a few years now for Audio Playback just thought others might be interested since they now have DSP and ADC versions. The only other cards I've seen where either low

Scott, The TP's are for RF and not for DC voltages. Raj

Pat Just a few things. I would do some partial assembly of the raduino, main board etc to get a feel for things. Many in qrp community like bnc, of course idea is to do it the way you want it. For

OK, my bitx-40 arrived today from GigaParts. I misspoke when i said it was $20 more than ordering from India withthe DHL option - it was only $10 more. $69 plus $10 shipping versus $59 plus $10 DHL.

I opted for the Audio injector Ultra sound card instead.

Dennis, Sounds like you have an ubitx. Please verify your kit model. My Bitx40 doesn't have these extra parts but my ubitx does. Big difference in wire up instructions. Paul KL7FLR

Just to add I received my Smarti PI Touch case for original PI Touchscreen I bought few years back and haven’t used because it was flemzy and awkward. This new case not only mounts screen with PI

Hi This spreadsheet of expected voltages is useful, but is there a table of expected voltages for the actual test point numbers?? TP1, TP2, etc.? This would be even more?useful as, on the v4 board,

Thanks Jack.

Try here, about half way down the page: amunters/bitx40-raduino-v2 | | | | | | | | | | | amunters/bitx40-raduino-v2 Raduino sketch v2 for bitx40 with digital BFO. Contribute to

My BITX40 v 4c kit has three resistors and a diode loose in the package of connectors and other parts. I have not been able to find any instructions as to where these resistors should be installed. I

I left the word NOT out...! Sorry 'bout that. Jack, W8TEE