开云体育

A camel is a horse designed by committee. Steve kb1chu

Hi Bob, The box I put mine in is 6.5 X 7 X 2.75. If I put my heart into it I might make it slightly smaller. Is 8X8X3 a standard, off-the-shelf size? 73, Bill KU8H -- bark less - wag more

Arv: All tough questions, but worth answering. Think of the possibilities. Personally, I think this should be of the free-to-use license, mainly because I don't want to see extensions to the bus that

My dad is an EE and worked for fm and am broadcast stations around Tampa Florida. I recall him working on a fm exciter one of the djs were using as a pirate transmitter. The boards all plugged in as

Form an IEEE committee! Control bus signal conflicts would be a challenge as they are when you try to stack the third Arduino shield designed by different groups. Also add a clock bus. At least 3

Please see the "Files" section listed in the next note, below. All info is there. 73 Kees K5BCQ

This is a good point of discussion. Jack, W8TEE

Hi Doug, I used your method with great success. I did however, substitute R3 with a 1k pot connecting the wiper to C1. I wanted to be able to use an amplifier on digital but not at full uBitx power.

I have a new tested uBitX transceiver of the pre built type. Will it have a voltage protection for this IC included or do I have to add one? Many thanks, John vo1jcc.

Mark I replaced R250 with a 10k trimpot to set the level. R250 is located at the front of the main board at the right edge of the Raduino board. Skip Davis, NC9O

I suspect that some of our 3D printer gurus could come up with a card cage to mount the motherboard to. I used a lot of Prolog STD-BUS products a long time ago and they had very nice plastic card

How do you order these boards is there a web page chris in the uk

The sidetone level is dependant on the level of the volume control, so as a temporary fix you could turn your volume down slightly when you start sending and then readjust it on RX.? A permanent

Bill; The Ubtix takes a 8x8x3 box the fold down DRO is very interesting I have a Engineer/designer son in law I will fwd this to him and see what he comes up with, I want to take mine camping and this

TAPR has a kits for the HDSDR project which has a bus board called Atlas. Perhaps it could further inspire a hambus. The documentation at the bottom of the kit page describes it in

If hams were to design and standardize a ham-bus-system approach to modular equipment, should the design be placed in public domain, or under one of the free-to-use licenses? Should a group be formed

The FIRST thing you are supposed to do when you receive a package from a freight company is examine the unit being received. If it is damaged you file a claim with the freight company - IMMEDIATELY!

Ray you said “They sold the kits, who else should I blame for damage in transit?”. Although they did sell the kit Farhan didn’t deliver it to your door personally. The first person that should

I solved it by using a single row of pins to the motherboard. The mounting arrangement included two slides (front and rear) attached to mounting panels.? The socket mounted on the motherboard was

Chip, Attached pdf file of RMS and DC voltages in a working RF section that was put on the board sometime after the first of the year. I believe either Glenn VK3PE or Jerry KE7ER made it just can't