开云体育

What range did you use on your meter? The ones in the transmit chain are working so when in transmit, you should have 0.6V there. Howard

Arv: When properly driven, I see the spurs almost at -60dB. Howard

Arv, You're right, it works at 15,12,10m. And while I don't have a spectrum analyzer to verify this,? my impression is that with mike gain sufficiently down the signal is legal. Unfortunately, if

A VERY IMPORTANT point! I'm fortunate to have an Icom7300 with a visible spectrum ?display. I ordered a handy smeter kit and am going to put it on the ubitx Mike input line to set the level

To check if the trifilars are shorted I have to unsolder them, so I wait a little with that. But I measured the 3904:s. All of them had zero volts between base and emitter. I also measured the voltage

Ouch! Then they can snatch GOOD programs to use and sell for free? Except for their buying price?

Microsoft’s Open Source Coup: It’s Buying GitHub for $7.5 Billion https://insights.dice.com/2018/06/04/microsofts-purchases-github-75-billion/ Vince - K8ZW. -- Michigan VHF Corp.

The uBITX does actually work on 15M, 12M, and 10M (and yes it does work on 11M as evidenced by the number of CB'ers who have purchased it). Power output is much lower on the higher bands, but is still

The advice given at this thread works well to get you back on track if your calibration gets knocked out of wack: /g/BITX20/message/47750 Dan, W2DLC

inline wattmeter? set as needed to keep from overheating.? PSK31 about 1/3 to 1/4 power. It will be different for different modes and bands. Many of my radios don't have ALC to watch so you need to

With the 86mhz filter you need 98mhz and 74mhz for downconversion to 12mhz. Thn you need LO to signal, with 86mhz filter maybe (have to run a spur table) 83 down to 55mhz? (LO below IF) will work.?

Congratulations Michael. Is a DRA-ITX or a BIT-KE rsrsrs Nicely done. 73 Saulo PY7EG 2018-06-02 17:42 GMT-03:00 Michael Hagans via Groups.Io < mikehagans@...>:

Sorry for my question if answered already. I want to know whether ubitx factory firmware support cat control or i need to install others.

Howard,? I called CQ a couple of times after I talked to Stan, then went to bed.? Dan, W2DLC

How does one determine the correct output level from computer to mic in on the uBitx for digimodes like FT8 JT65 PSK etc.? On my FT817 / 897 I watch ALC level. How to do this on the uBitx ? Jan PD0JBZ

For the very low bands and narrow bandwidths I'd thing simpler radios would do well.. Allison

Allen: No one solution is going to be the right fit for all. The fact you can do what you need to do with the Nextion is great. Al and I chose a different display because we intend to have it

The more I play with the Nextion ?Suite and get use to it the more I like it. As with the button you just click on button and it is done for you, it has a field for you to put in what you want it to

That is good news, I would look at one of the trifilar interstage transformer being shorted. I mentioned the numbers earlier. If the transformers are fine then a dry solder in the RX chain or filter

Thanks Raj, I will look on that! But now a little more info: I looked up a very strong broadcast station at 13.580 on my little transistor radio (with a small telescopic antenna) and I could hear on