开云体育

Could be. I never knew such a thing existed. I guess I should get one of those. Also a USB-C one (which I definitely knew about). -- Buddy Brannan, KB5ELV, WRVB670 - Erie, PA Email:

I'm just a sucker for trying to use the least expensive gear....so even though the sBitx / transverter system just couldn't create enough sensitivity.... I ordered a GaAs FET preamp with up to 20dB

Same issue here. I am looking for the settings I used on my Sbitx, to see if that helps. As you indicated ft8 rx is working TX or any cat commands don't work Joe VE1BWV [email protected]>

probably impossible since the IF is around 40MHz use a transverter

Wouldn't a micro usb Ethernet adapter work also? Allowing you to access internal RPi? https://a.co/d/770Lyeh Ken, N2VIP

Gary, Hope dies last because you've read a lot about it but haven't seen it in action. This device is an RPi-controlled SDR radio, packed as small as possible, with its advantages and

I’ve had the same question for some time. For reasons, local access to the Pi, at least initially, is going to be difficult to impossible for me otherwise. -- Buddy Brannan, KB5ELV, WRVB670 -

If nothing works, download the Image, extract it to .img format (32GB), copy it to a good quality uSD card with balenaEtcher and use that. This has the latest version. -- Gyula HA3HZ

I copied the zbitx Image today because I was curious about a problem. I have sbitx v2, the hardware is different, and the program logged in fine after starting it. If you changed the password in the

Password hf12345 user pi

Try using "raspberry", that looks like the password for the Rasberry Pi itself. Thank you Jim KE0VVU

Just joined the group.? I ordered my zBitx on Friday....on the 4 week waiting list.? Looking forward to playing with this radio.? I belong to a group in Chandler, AZ called "BE-HIP" (Hams In

hf12345 does not work.

Is it technically possible to open the sBitx / zBitx to use 6M or is it hardware limited? #sbitc_v3 #sBitx #sBITX_v3 #zbitx

I don't know if anyone has noticed, but the spectrum display frequency window is not centered on the frequency, the water fall is perfectly aligned but not the spectrum. I hope I explained this

Hello Gyula, I am following the procedure on page 22.? When I hook up HDMI monitor, keyboard, and mouse...then power up the zBitx, here is a pic of the screen I see.? No password, even the default

It is a "birdie" All receivers (well, most anyway) have them. You can try more internal shielding on the radio (there was a great thread on that before, suggesting that shielding the display cable was

Yesterday the rig was on all day and that line was there but not always irritating. Well, today I started up and no line or noise. About 10 minutes into the session the line and the noise returned and

Andrew, There was a comment here on the forums that decode works best when the radio's speed is set to the incoming CW speed. And, as others have commented, don't rely on the decoder, for when it

Not that it is any easier, but if you don't have an HDMI adapter etc., can you open the radio, pull the microsd card, and copy a wpa_supplicant.conf file into boot folder with your SSID and PW to get