开云体育

Thankfully.

I recently tried my hand at PSK31 on my new sBitx v3 with 64 bit software. Keep in mind, anything having to do with the digital modes is *very* new to me. I received an email from someone who

DROK Buck Converter 12v to 5v, Voltage Regulator Board DC 6.5-36V 24v Step Down to DC 1.2V-32V 12 v Volt Transformer Reducer 4.5A 75W CC CV Power Supply Module [email protected]> wrote:

I have bought several dork supplies good for 5 to 30vdc 10 amp... from amazon [email protected]> wrote:

I just ordered one.? It's about time I got a decent bench supply. Gerry

Or this as a simpler but much less versatile option: https://www.digikey.ca/en/products/detail/mean-well-usa-inc/GST36U09-P1J/7703697 That’s the Canadian Digikey site. Here’s the US

Anyone have a Sbitx DE non working that they would like to get rid of. I am in search of the main board. 73 Art

What size is that?

As noted on zBitx page at hfsignals, a barrel connector, and one is included with the radio. Assume it is same size as the power connector for sBitx ken, N2VIP

What style power supply connector is used? Ron

https://a.co/d/cQmErlL I would guess something like this would work well. David [email protected]> wrote:

I'm looking forward to this little radio! I'll probably end up using it mostly on battery power, but does anyone have any recommendations for a low RFI, small, 9 volt power supply capable of running

Thank you, Evan. The problem I had with getting the sBitx software to work with ION2.G (the ALE software that U.S. Federal SHARES wishes to use) is that their CAT controller expects the radio to

In addition to Gordon's response, the uBiTx's polling response could be too slow for the needed response set in the FreeDV program.? For example, changing the frequency too fast.? The Nano in the

could it be that the ubitx emulation is not sending back responses needed by the FreeDV controller? Gordon KX4Z [email protected]> wrote:

I'm trying to get it working but FreeDV apparently doesn't like the FT-817 hamlib setting.? Usually when I try to test the cat function I get a hamlib message saying it failed to connect and/or

Retrying, Is there any voltage analysis not DC, Signal levels. What to expect at each stage. Thanks. Ravi/M0RVI [email protected]> wrote:

Everyone can change their mind, and HF-Signals has also learned something – as have I myself. No offense intended, but somehow you seem to have a problem... Sent: Sunday, January 26, 2025 10:54

I have an adjustable power supply,? I have it set at 13.8 volts, What is recommended? I got it on Saturday Upgraded to 4.3 64 bit on Sunday on Monday I kinda modded the mic and get pretty good audio

Hi Gyula, Thanks for your suggestions. Im using Atas 120 antenna? and also a loop 7/30Mhz Yes sure I dont keep sBitx on a shelf I have a lot of fun to discover it , and now time to TX has