开云体育

https://a.co/d/cQmErlL I would guess something like this would work well. David [email protected]> wrote:

I'm looking forward to this little radio! I'll probably end up using it mostly on battery power, but does anyone have any recommendations for a low RFI, small, 9 volt power supply capable of running

Thank you, Evan. The problem I had with getting the sBitx software to work with ION2.G (the ALE software that U.S. Federal SHARES wishes to use) is that their CAT controller expects the radio to

In addition to Gordon's response, the uBiTx's polling response could be too slow for the needed response set in the FreeDV program.? For example, changing the frequency too fast.? The Nano in the

could it be that the ubitx emulation is not sending back responses needed by the FreeDV controller? Gordon KX4Z [email protected]> wrote:

I'm trying to get it working but FreeDV apparently doesn't like the FT-817 hamlib setting.? Usually when I try to test the cat function I get a hamlib message saying it failed to connect and/or

Retrying, Is there any voltage analysis not DC, Signal levels. What to expect at each stage. Thanks. Ravi/M0RVI [email protected]> wrote:

Everyone can change their mind, and HF-Signals has also learned something – as have I myself. No offense intended, but somehow you seem to have a problem... Sent: Sunday, January 26, 2025 10:54

I have an adjustable power supply,? I have it set at 13.8 volts, What is recommended? I got it on Saturday Upgraded to 4.3 64 bit on Sunday on Monday I kinda modded the mic and get pretty good audio

Hi Gyula, Thanks for your suggestions. Im using Atas 120 antenna? and also a loop 7/30Mhz Yes sure I dont keep sBitx on a shelf I have a lot of fun to discover it , and now time to TX has

Patrick, if I may suggest, use a current limiting power supply and you will save yourself from frequent soldering. I also have a v2 and at first it worked on battery, then one day I noticed that I had

Thanks a lot Farhan. 73 Patrick

Do nothing. Start transmitting with the drive low and increase it [email protected]> wrote:

Hi group I bought an sBitx V2? #049? in April 2023 and put it on a shelf... Some weeks ago, I put? battery 2032, power on, update software with JJ 4.2? setup call,? Wifi, time, and play in

Thanks Farhan, Would there be a possibility of the signal levels in Vpp at T2 on pins 5,2 and 6,1 too please? Is T1 9 turns - on FT37-50? I might have missed this information somewhere if published

Ashhar: Your diagnosis was absolutely correct! A bad cable between the rig and the antenna tuner was not making contact when it heated up. This caused a very high SWR. Now that the problem is

It is now sold.

I upgraded to the 4.031 firmware and the rig is working great Thanks art

On eBay: https://www.ebay.co.uk/itm/387858673027?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=wLCdxH6VQgu&sssrc=4429486&ssuid=wLCdxH6VQgu&var=&widget_ver=artemis&media=COPY

Here are some similar re-posts from Jens: /g/BITX20/topic/110811885#msg115362 ( /g/BITX20/topic/110811885#msg115362