开云体育

Thank you everyone for for your support. I will try the remedy and update here for outcome. Regards Ashok

VU2ZAP has given a nice reply. Similar problems cropped up in case of a friend's FT8 interface. 0.01ufd and 0.001ufd MLCC capacitors cleared the mess. 73 de VU2UT gmail.com@groups.io> wrote:

Its picking up RF and locking. Try adding 0.1 or 0.01 uf across the DB9 wires and also the 914s and see Raj

Hi all, In my uBitx v6, I am trying to do CW keying from a PC through serial port. For this I used DTR line from PC and used optocoupler to couple the CW port in radio like below: Problem is it

Ron, That's exactly what I did n my uBitx V6, I removed the speaker and turned the top plate upside down, I then counter sunk the speaker holes and remounted it back in place. The 5 volt regulator

On the other hand, having the cooling over the 5 volt regulator may lead to better frequency stability.? Or if you want to add things to the case, the top on backwards positions the speaker in a

It's ok now ?

Works on my iPhone right now, 8:45 central time. Ken, N2VIP

Some newbie a while back did put it on backwards & then posted the picture. Gerry

Link does not word Invalid SSL certificate gmail.com@groups.io> wrote:

Thanks a lot to all the answers! 73's Rafael

I had no question on which way it goes, seeing as it positions the vent slots directly above the finals! John

Gerry, Thanks for the reply and I thought that there wasn't any way to fit them on but wanted to be sure.? I also just bought an sBitx v3.? I haven't been active in decades and I'm working towards

Just a comment for new users of the"6":? I have seen images of the 6 with the top panel on backwards.? The cooling air vent slots are on the back of the panel.? The panel can be installed the wrong

John Don't worry about the nuts on the jacks.? I had the same "problem".? Can't remember about the volume control, but it's all rigid, so there's no problem with operating the radio. Your posting

I'm new here, so hopefully I'm posting this correctly; I just bought the uBITX V6 kit and have assembled it with no issues other than the fact that the volume control as well as the key, headphone,

Thanks Farhan, That's what I thought, the board looks very clean, I like that. Joel N6ALT

How bout support for a nextion screen that way you could have different sizes as needed/wanted, just like hotspots.

The differences are mostly to optimize production and move more components to smt. gmail.com@groups.io> wrote:

I recently acquired a second V3 sBitx and while doing some mods on it I noticed that the board version is now V3.02. Does anybody know what the changes are? Some things I noticed are that a lot of the