开云体育

Hello everybody. I am trying to download the image for the Sbitx sd. i couldn't download it, despite trying with win10m win 7 and win xp. I can't finish the download. do you have any ideas? I should

Hi! APP software connection and download failed, Can the download link be re-provided? or email me xyjlxx@...

Refer the Video of "uBITX_6_N8ME_3_VU3GAO_Mods" running on the transceiver.

The first thing I would do is make sure the sBitx is getting power. If you're powering it through a fused cable or a distribution box like a Rigrunner, you might have taken out a fuse. I did that in

Tonight I had made15 contacts via ft8 with no issues on 40 meters through a vertical with 1.2-1 swr.? I switched to 20 meters, and adjusted my vertical till I had a 1.1-1 swr.? Mid-transmission, my

William, The kit has been despatched to everyone who has bought sbitx (either models) with LM338, across the countries. - f wrote:

I asked this question a few days ago but that post seems to have vanished from the earlier thread on this topic, without a response. Has the upgrade kit been sent to purchasers outside the USA, Ashar?

*not working for me Nitin.. cfg menu brings up some corrupt graphics. key mode not saved*

I agree - The cost is not an issue as the parts are cheap and readily available.? I am just waiting because I don't want to end up buying a regulator that happens to be very noisy.

Is there any utility in adding an L-C noise filter, or would that be overkill?

*ok Nitin, noticed the new file. thanks*

Chuck,koodos on what Dave,K8WPE said. This is a Hobby. And even if it wasnt, We all started from the ground up. I remember when i first was licensed,my young brother and sister made fun of me by

Evan,I have N8ME software installed on my ubitxes,and i must say it makes the ubitx a new radio all over again. It cuts out the latency ,or delay from key close to transmit. Also it seems to me on my

Hello Art, Please use the updated firmware where I just fixed the bug of Keyer not saving. Do let me know. 73s, VU3GAO Nitin William

The following files and folders have been uploaded to the Files area of the [email protected] group. * /uBITX_6_N8ME_2_VU3GAO_Mods.zip ( /g/BITX20/files/uBITX_6_N8ME_2_VU3GAO_Mods.zip

Hello Howard, I have fixed the minor bug of Keyer not saving. Update file has been upload to the same location in the files section. Please do try and let me know. Thanks Nitin William VU3GAO

Chuck, quit apologizing for errors!!! This is a HOBBY! Most of my mistakes, errors of omission and commission are now called learning experiences. We learn best that way. I have great tales and one of

Chuck, Glad you found the issue.? Let us know how the N8ME CW works for you after you have used it for some QSOs.? I am not a CW op, so I can not test that aspect of the software. 73 Evan AC9TU

I feel stupid. Evan in your reply to me to make sure CW was selected , Then which it was but you said about checking the config. I did here I was suppose to be Iambic B and it was in Winkey . Set it

What ever the reason be, when I switched the PTO and RF input, the receiver went from dead to impressive. I have rebuilt the two mixers three times and ended up with the same results. I finally gave