开云体育

This might help: https://www.youtube.com/watch?v=3n_V3prSJ_E&feature=youtu.be 73 Evan AC9TU

Thanks Andy, that is helpful.? What I was looking for was instructions on how to apply the latest version to my uBITX.? Do I need specific software (IDE?) or am I just downloading the file, and

GigaParts has the uBITX V6 full kit for $209.? That includes shipping.? I purchased one and it came quickly.? Its firmware is version 6,1. Vic, W9RGB

Rene Some thoughts that may help. 1? As Mark says, 800mA without modulation sounds about right, you will be able to detect some residual carrier (carrier leakage) on a nearby receiver.? This will

What are you using for a power supply, an unfiltered power supply is capable of putting rf into the radio, locking it up. 73 Dave ADOB ( https://www.qrz.com/db/AD0B ) Raduino bracket and Ham_Made_Keys

I had similar issue when trying to compile for the Enhanced display.? I believe it has to do with the updated Nextion editor, though I could be mistaken.? I was able to load one of the previously

On the read me of that zip folder it tells you how to place the file folder and rename it. I did mine the other day following that read me ?and it worked. But i did not use arduino to load the file,

Well a bit of a back story ?i just got my ubitx v6 and after messing with it for a few days decided to do the nextion conversion with the cec software. Here is were i ran into issues. The screen i

cannot get any of the controls to respond just get start up screen volume will adjust? nothing else will reaspond

Mark You might want to set up a git hub account for yourself. It is common developer collaboration type system for collaboration. Ashhar has a github account where he posts his latest versions (busy a

As far as loading the software into the nextion the best way i found is using an fti cable. In my case i used my baofeng programming cable. I just ran wires from the jack to the nextion temporarely.

Looks to me like black is ground (sleeve), yellow (tip) is mic, and red is PTT (center).

The electrets were like 6$ on amazon for 20.

I used the 10mm electrets from amazon and soldered them in the mic. The mic element in yhe baofeng is 6mm. You will have to modify the mic enclosesure for it to fit. I mounted mine to were the mic

Try going into the setup menu and doing a screen calibration. That was needed on one I was playing with. =Vic=

!! volts may be too low. Try for at least 12.5 .

hello i have just finished my ubitx v6? the diplay comes up ok shows bands etc and there is a hiss from the speaker but the touch display is not? responding? im running at11v? and the ammeter is

Where can I find the instructions on how to update the stock firmware with the latest (stable) stock firmware?? Mine came with 6.1 so i assume I want to update that. -- Mark, kb9woo Milwaukee, WI

Hello all, The annual Sasquatch Stomp is just a week away, occurring on April 3rd, next Friday. Check out the details here. https://sites.google.com/site/pnwqrpgroup/sasquatch-stomp This is a fun

Hi Folks! How to connect this microphone to Ubitx?