开云体育

Actually credit Martin with the save. I merely get an assist, maybe. Enjoy exploring the new rig. Curt

Thanks Curt That was the problem, the red wire was crimped with the insulation making no wire contact in the digital connector. You made my day -Thanks again Bill K9JUI

Please put me on the list for 3. Thank you Bill Ng1p

Look here: https://drive.google.com/file/d/1CpfVWastQRHWSDt_TC9Dd2PHnLdrG_9a/view =Vic=

Oops ! And many thanks to Alisson too. 73'Olivier <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> Garanti sans virus. www.avast.com

Many thanks Ted. (with the colors, it's more simple to understand). Yes my rotary encoder put out 5v pulses on an A and a B channel when I spin the dial. I will try this tomorrow. 73' Olivier.

Hi I just did this to keep the 7805 a bit happy tnx 73 de Pop VU2POP Sent: Friday, March 01, 2019 4:08 AM To: [email protected] Subject: Re: [BITX20] Bitix 40 5 Pin #bitx40 Regulator sticking out?

It looks likely that the Si5351 output is not connected to the main board. can you check it can transmit? - f

Bill After pushing button notice rig will no longer transmit. After pushing button, turn the encoder to see various menu selections. To choose the one displayed,? press the button again.? you pretty

Thank you. Will look forward to the board. Dan W3BU

There is some discussion about a transformer at the mic input affecting the output. It works on two of my v3 rigs. There is a blocking cap c60, a 1uF on the input of the q6 the mic preamp. I would

If you are sure that the button is working OK and that the wires to it are correct, be sure to check the connections at the other end -- correct pins, not loose, etc. I read somewhere that some of the

The AGC's are in and looking good. I need to finish up packing and shipping the pre-orders and then we will open the gates for the rest of them. Install and switch wire up instructions will be

Folks, this depends on what impedance it is feeding into. If it’s feeding into a very high impedance say 100,000 ohms, then it will be relatively flat Likely the input impedance is a little lower

excellent...thanks. Working on expanding v3 nextion gui to 3.5" and want to add a tune function.

If your using the KD8CEC firmware you also have cat control for keying the rig for digimodes via the serial interface. -- Tim Keller - KE2GKB https://shop.kit-projects.com

The key is hooked up to an Arduino input pin, nothing else sees it. Your software can ignore that pin and transmit CW whenever it wishes.

In addition to being simpler than adding a clean audio oscillator, and cleaner in that it avoids issues with residual carrier and opposite sideband, this scheme will allow adjusting power out by

Hi everyone, Before I start digging around, can anyone confirm if the rig can be keyed via software or do I have to physically short at key? Thanks

Thanks for the info on the resistors.? I thought something like that. still have the question about the push button. Thanks? Bill K9JUI