开云体育

I have to admit I do talk to it when I am working on it. But I always finish ,or at least as much as possible, finish what I start. Not having any real RF test gear I wont know if I am “legal” or

I recently assembled a uBitx and would like to add a Nextion Enhanced 2.8 screen.? The instructions that I have found seem to be way above me. when it comes to finding, downloading and installing the

Dave Just take out the circuit board and cut through the traces around the two switches. Solder in two resistors and jumper the other end of the switches together. On mine I covered them with shrink

Sweetness!!

Agreed all 'round. Long-term the paddle is best. Operates with a roll of the wrist! Just getting into Ham Radio(50-odd years ago), my Morse tutor was George Studd, ZL2AFZ, a DX Ranger. A visit to his

Dear Peter, Hi again, I will take those off you hands.I assume the PayPal is as for the ubitx I bought yesterday.please just confirm and I will PayPal you. Many thx. 73. Ian Reeve M0IDR Get Outlook

As you may know, I've sold my V4 ubitx - shaking hands and poor eyesight are not conducive to working with smd's! I've still got quite a few SMD inductors (about 200 ) for the 45Mhz filter mod, so if

Hi Dave, like the idea of a mouse,any chance of a look please.regards Dave.

Er ...That would? probably have been me ...Photos attached ..Note new Q11/Q31 have to be mounted "upside down" and rotated to get the pins lined up as per photo ...Also need to change R14-R34 from

Mike I think some frustration indeed but I trust you will indeed get this unit working to your expectation and within FCC specs. What I would suggest is you work on that with as few additions as

two capacitors: one ceramic or other cheap one, anywhere from .0047 to .1 microfarad the other an electrolytic, anywhere from 10 uf to 100 uf both across the power wires, as close to the board as

In addition to the residual carrier, the uBitx also has significant IMD and some opposite sideband, though that should all be close in to your main signal and more or less legal anywhere AM phone is

This is a critical bit of information regarding how best to set up a uBitx, should be in the hfsignals description of the uBitx. Many here are just turning up mike gain and/or RV1 for max power,

Any recommendations on the capacitor to use and exact placement?? I'll get to work on it this weekend. Thanks!

Only been a ham for a year but am near 70. Can see the point of slapping the hand one way or the other when I get old enough. A computer mouse has some interesting parts in it. Have thought about

I got my 5.1 calibrated successfully.....So far very satisfied with this new version....Thanks for all the help....Mike W4ZGI

Hi Ashhar, Been following this for some time I think I remember someone talking about changing q11 and q31 to a pnp and getting more gain. Then a couple of weeks ago another ham mentioned that his v5

Jack, I agree with you. As a ham of 45 years you are exactly right, however,? you cannot deny that using the mouse in that manner is unique and embodies true ham radio spirit.

Dave: I may be way off base here, but I would discourage you from using a mouse as a keying system. First, when you get to be two years younger than dirt, fingers just don't work like they used

My wife and I are learning ditties, morse, I saw the neat built in iambic keyer and thought I need one. Looked around and found a dead computer mouse, just perfect! Took it apart, scraped some of the