开云体育

You get tracking number when paypall notifies on shipment. You can use India Post tracker (aftership). Probably when it arrives at your country you local carrier will address new one. Could at least

Can anyone that's already received a BITX40 tell me if you get any emails that confirm when the order is shipped or even maybe a tracking number? Or is it just a surprise when it shows up? Thanks,

Hai all The BITX40 board arrived intact and connected and put in a neat metallic cabinet. Rx is working excellently well. Unfortunately the Tx is yet to perform as prescribed. The PA is drawing only

Compliments of the season to you all. I have spent the last 3 days putting my rig together and playing around with it. It is temporarily mounted in a plastic food container and receives very well. It

Hello All, I have been watching all the posts over the last few weeks regarding the VFO/DDS question for the Bitx40, Let me say that I got one of the earlier Bitx40's and immediately converted it to

Sent from an iPhone, don't ask whose. When the ADC is set to 5V full scale the reference is the 5V ADC supply line so it is ratiometric, meaning the ADC reading (in this case) is independent of the

I'm using the 5V supply from the Nano but they sometimes are lower like 4.7, so I thought that might affect the upper end. I have not measured it yet, I will do that tomorrow. I do have .1mfd cap

& all digits in between...

Rotary encoder also contributed noise when touched, like AK47. Good solution... Rotary encoder has in built push button that can be used as step size, 1 Hz or 10 Mhz... Carbon film Pot don't last

This could be what I call a "corner bug"...a bug that hides at the extremes of a variable. I haven't check this yet, but keep in mind that the converter has 10 bit resolution, so the range is 0-1023,

At times, the noise contributes to this as well. Solder a 0.1uf capacitor across the pot's ground and wiper lugs. - f

It should work if you have derived the same power line as the Arduino's 5v line. in the function doTuning(..) there is a line that triggers the step up beyond 1010, you could reduce the 1010 to 950

Farhan, I breadboarded your Raduino to try it out, and I have to say I rather like it, however sometimes when I turn the pot all the way clockwise it won't go into the mode that counts up at a higher

I do use a rotary encoder to tune my Forty-9er (see March, 2016, QST) and will likely soon add one to the BITX40 I just bought. The increment is an issue that is often one of personal preference. For

Ashhan, Thanks for the reply. ?Yes, I understand the tuning element is a pot driving an ADC and the limitations of cheap rotary encoders. ? 50 hz is a pretty big tuning step, I just played around

We are onto it. We are meeting a box manufacturer today who has promised us something durable within a few days. - f BITX20@...> wrote:

John, the step size is 50 Hz as shipped. the tuninng is not by a rotary encoder. it is with a potentiometer. here is how it works: - The tuning pot is connected to the ground and 5v lines. The

Hello Ashhar, After listening to the packaging issues from many on this Yahoo Group, and from my own experience, I believe the weak link is at the corners. My parcel also arrived with one on the

Can anyone tell me what the tuning step size is for the SI5351 / Radunio version of the radio?? Any info on the DDS noise pedestal - - does the audio sound as clean as the analog VFO version or does

Looks great! I can't wait to try and get my other code working with it, too. Jack, W8TEE To: BITX20@... Sent: Monday, December 26, 2016 3:02 PM Subject: Re: [BITX20] Re: Raduino