开云体育

I set it to 11.554. Didn't notice any difference in the ubitx. I'll dig out the scope. I'm sure there's a reference for the Raduino out there somewhere. [email protected]> wrote:

I’ve got the 5 volt issue reasonably working. The Drok module combined in series with a LP filter has significantly stabilized the critical 5v line. Had to play with grounding but ended up grounding

That value is too high. ?It should be below 11.057 at most.

I had it set at 11.0581. I didn't see a 'fine' adjustment, but I can look at it tomorrow. I do have a 50mhz scope. [email protected]> wrote:

I did some static testing of the DROK regulator module and it was interesting. I wrote about it on my blog

Don, This looks like the "course" BFO setting used to zero beat the AM signal.? Note that there is little to no signal above 1.8 KHz.? What values are you entering when you press the tuning knob??

Well, I got the frequency dialed in. I can't get the BFO set though. I'm using Friture with a USB mic (on my webcam) laid right on top of the ubitx speaker, and I can't get anything close to the

Congratulations Dean. Now waiting for you to share your build details with us. Charudatt - VU2UPX [email protected]> wrote:

Thanks Evan. I lack a signal generator, so I'll have to stick to WWV. HF is pretty quiet here in Seattle at the moment. I'll give it a go in a few hours. [email protected]> wrote:

I think it would great to have VHF/UHF/SHF sBitx.? Maybe a poor man's version of the ICOM IC-9700?? A gBitx?

Thanks to JJ my homebrew sBitx is now up and running on the 64 bit release and all is well.? I'm going to be testing over the next few days but I will likely keep it.? The 64 bit OS feels like the

Could you post a picture of your waterfall with the noise?? Maybe with the band spread set to 25K with a dummy load or no antenna attached? I mean if you have your IF GAIN cranked to 100% on 40M or

Don, The signal that Asher Farhan is using is a short wave station in India. ?Any AM signal can be used. ?I use a 10MHz reference source. ?You can also use a frequency generator. ?WWV can work.

Thanks Evan. I think I messed it up when I reloaded the firmware, just to see if I had my Arduino environment set up correctly. Where is this 7270 signal? I could really use any signal, like WWV

Hi Don, The radio's calibration may be off.? The radios are calibrated in the factory, so the following should be done carefully.? Unfortunately, the stock software does not know the current

I got a ubitx v6 some time ago, and haven't done much with it. I just started tinkering with it. This is the stock firmware. Changing USB/LSB seems to have no effect. Is there some kind of

Gulya, you’re one of the heavy hitters here so your response is interesting. I appreciate the attempt at constructive criticism. Your inference seems to make this about me. I much prefer to stay on

Welcome to sBitx owners. It seems to me that you have little knowledge of what HF ??Signals does that is worth knowing. What I know, I've read online. In the beginning there was Minima, then the

All - v3.026 is now available for installation. Change list: * sBitx app now selects the RTC and reads it if present or copies the system time if no RTC is present. * hamlib NET RigCtl is now more

We feel your pain...