开云体育

I occasionally have run into a situation where the V6 is left in transmit mode, but no actual signal is being transmitted because the laptop locked up.? ?In my case it appears there is an issue with

Hi Mark, I am going to display my ignorance here as this is all new to me.? ?I have watched your video on how to try CEC V2 without risking the current system, and would like to do? this.? ?I

My uBitx v6 was working fine - running half watt on ft8 using SignaLink and laptop. Suddenly it's stuck in transmit, several watts, whenever powered on. Any ideas appreciated, as I start to look at

Joel, I also remember reading the post saying there would be a process to calibrate the DE with V2 software.? I assume he referred to a DE with the SWR/PWR sensor.? He did post that. As far as I

PSU not up to the job? [email protected]> wrote:

Evan, No, I only ran txcal once after upgrading to V2 software before thinking about it. I do remember Farhan saying he was going to make some instructions for us DE users who upgraded to V2 to

Joel, I thought that txcal required the SWR bridge to be installed. ?How else would the software know when the power out was correct? Are you running txcal each time? ?If so, that will reset the

Hi Evan, There has got to be a easier way to do this. The whole spread sheet thing doesn't make sense to me at all, the lower percentage number is how I lowered it with the V1.? software so I get

When in transmit, the TX lamp flashes on then off repeatedly. Does this tell us something of what may be wrong? Bill

Thank you, Ashhar. I need to restock my toroid collection anyway so I will put some of those in the order.

Hi Joel, I have found that you adjust the power levels by editing the hw_settings.ini in the /home/pi/sbitx/data folder. 1 - I would first verify that each band can operate safely below a max of 50

Farhan had mentioned a couple of weeks ago that he would provide a detailed procedure for calibrating the power output on DE radios running V2 software without the SWR board installed, has this

Having some weekend fun with an stripped down alternative Web UI with a monochrome color scheme. https://drive.google.com/file/d/1WP4bKjEoKKtfpmh5jQtl_0qEgQbsw4SF/view?usp=share_link

Yes, definitely interested in how you configured your sbitx digital VE1BWV Joe

Got it from Thomas George of HFSignals.

It would probably help others if you could post the configuration. -- Gyula HA3HZ

/g/BITX20/message/102612 -- Gyula HA3HZ

Folks, is any of you have an open V2, please reply with a pic of where the RTC plugs in? This test peice came with it rattling inside. 73 Raj vu2zap

Jack, I could not sleep this evening, so played with the sbitx code.? It turns out that si5351v2.c line 45 needs to be uncommented, and line 46 commented.? Then you get to play with the value of

Hello, I will be happy. I want to use the Qsstv, It may help. Regards, Nir