开云体育

Rajesh, That error usually is for baud rate issues.? The supplied Nano from HF Signas, and most all of the clones, use the CH340G USB chip with an older bootloader program.? That is selected through

I have a v6. I expect you are tuning to the correct frequency, but the local isn’t dead on. It won’t be. The closet I got was .020 but it worse on other bands. I set it on 40m and deal with it

What does the error message mean Error Receive Length = 1/1027

Yes Evan, I have the stock raduino working fine. I another one for the CEC firmware. As I am writing to you in the ubitx.h section on the ide screen the stock display or uncommented. Will they again

Hi Evan, Thanks for the revert. I am using the stock 2 line LCD which has come with the ver3 set. I will check the line in the file which has to be uncommented as there are several LCD display types.

Rajesh, Are you using the stock 16x2 display?? Did it work before you loaded the CEC software? I would check connections.? You may have disturbed something when connecting the USB cable to the

Hi, Have installed the cec 1.20 firmware on ubitx ver 3. Display does not.light up. What could be the problem? There are multiple LCD displays mentioned, which one is to be selected. Inputs will be of

Yes, that's exactly what I would like to do, if it's possible, it's just for fun, because already it works very well. We have to find a new challenge.

Good effort. I an not a coding personat all I suppose that we can do this way. before the line which displays the frequency add a clause, using a spare pin.. if the pin is high add a fixed value to

Hello, OK for the UT5JCW tranverter, no problem the frequency is good to within 200 hertz. for the output power I lowered it from 10W to 3W because I have behind an amplifier of 100W. as for the

I sent something from Kentucky to Michigan by USPS on a Thursday/Friday and was promised it would arrive the following Tuesday. Then the USPS tracking tool advised that because of the Corinavirus

Greetings all, I thought I would share my delivery time.? I ordered the uBtix V6 w/ case on 6/21/20 and received it on 7/3/20, that is about twelve days, not to bad considering the world status at

Changing antennas making it perform OK may indicate that you had high SWR on the other antenna/s. The RF could have caused feedback and received distortion. You may want to recheck the SWR on the

Hi, Peter. I'm sorry for the delayed response. Please don't take it as a lack of interest in helping.? I added a 22-ohm resistor to the bias resistors recommended in the case of other transistor

No problem... and I'm going to (when I get the chance) convert an old BitX20 I built to 10m for use with one of those transverters. I might mention that I've got one of those 144 boards and a 440

Michel Changing the frequency display to accommodate a transverter should be rather easy. Frequency display is already a calculated offset to accommodate the IF frequency. You would need another

Well that’s why we all buy kits like the uBITx … to gain knowledge. Good time maybe to learn a little bit about the Arduino. Remember you can always reload the original code if you really mess it

McRuss, Is the audio problem on receive or transmit? If on transmit, then the suggestions by Gordon are the first step.? Then go to the final BFO calibration in the 3 step process of Ashhar Farhan's

Add .001 Uf capacitor from the Mike lead to ground? Great chance for learning, frustrating as all get out .....been there myself many times... I have an older ICOM radio with the same problem. About

Maybe radio frequency interference? try the ferrites, check it out lower power to rule it out?