开云体育

Yes you could but make sure you get the levels going to the TT right. There are other arduino based VFOs that could do the same work. Either way your rewriting the code as the raduino does things that

Above 22.5 MHz, a HPF cuts in with a threshold just below 22.5MHz, again killing off all the unwanted mixer products.<<< Sounds plausable but then try a typical 7 pole HPF or LPF and see what it looks

Hey 7 watts works the world on FT8 & WSPR. ?. I'm using the stock model. Bo W4GHV since '54

Barry, just out of curiosity, what current and voltage do you run when doing WSPR? I sit at around 36 volts at 1.4 amps, and the heatsink I use gets a bit too warm to touch unless I run the fan which

No.? The filter in use for 18mhz is the one used for 14mhz and has a lower cutoff around 20-21mhz and the firmware selects the 35mhz cutoff filter for 21mhz or higher. They have no impact on low

FT8 does not have a heavy duty cycle. The other modes DO. I have a small 5v fan with a dropping resistor to quieten it, and the long duty cycle WSPR works fine.

The spur of interest is predictable;? ?Fspur= 45mhz - output frequency(mhz) For? ? Spur at 29? ? ? ? 16 28? ? ? ? 17 24.9? ? ?20.1 21.45? ?23.55 None above are filterable with simple

I too am having trouble, mostly with the Nextion library usage. I Googled "nextion display examples without nextion library" and am doing pretty good with just the basic commands in an Arduino

Yep, I have done that with a vacuum tube Heathkit SB 102 with a wonderful outcome.

Jack, that is a very nice looking display, very impressive.? Nextion ?users I would like to know what software is the easiest to use with it I downloaded their software and find it about as user

I found an old BUD box about 10x6x3 1/2 inches. The uBITX fit in just fine when I cut a hole for the display and out the back for the heat sinks. I later found a large heat sink so fastened it to the

I meant spurs transposed from the wanted frequency

That makes me think of the Purdum/Zia DDS VFO I just finished making work in the 40m rig I built from their kit/instructions. I pretty much rebuilt my dining room into a workshop just so I'd have a

Thanks, Allison. I'm actually going to stay out of trouble for the moment and wait until these mods are "final"-ized (pardon the pun. You know far more what you are doing than I can understand -

Ok, so this issue is of great interest to me. So far, CW is the only mode I've been working...and unsuccessfully at that. My uBITX is still using the factory installed firmware - I haven't changed

Ian, thanks for the quick reply. Mike N6CMY

I just bought a TenTec Delta 580 that has no ability to interface with a computer.? HOWEVER...it has the ability to add an external VFO. I wonder if a Radiuno could be setup to provide an external

Mharpen Thanks for using CEC firmware Yes, available on stock lcd (16x02 parallel LCD). Just check the S-Meter option in uBItX Manager. I am based on uBITX which was not modified when I wrote the

I used the info in this thread to wire up mine.? Works great for me! /g/BITX20/topic/16775725#47078

Question: ?will the S-meter feature in v1.08 work with the stock LCD? Mike N6CMY