开云体育

Got it trying for 4400, 4600, 4800, 4900. Too much interference at 5000 to tell. Going to try Farhan's sketch now

If anyone's interested in putting their BitX in a Pelican case, Harbor Freight is now selling Pelican clones and has the one that's supposed to be the same as the Pelican 1120 for $9.99 with coupon.

Hi all This thread has a couple of topics but this comment about tbe PTT pop only. This mod worked well on my bitx 40. ?/g/BITX20/wiki/AudioMute Unfortunately it will require some

Brave enough to retry Farhan's sketch? Or maybe first try something around 4.800-5.000 MHz. Vince. -- Michigan VHF Corp. http://www.nobucks.net/ http://www.CDupe.com/

Hi Allard san I will wire PTT sense ( A0 black wire) I am a?beginer for Arduino. I do not understand?what? mean??"This sketch version requires the library "PinChangeInterrupt" (

Ok guys.... something interesting happened and I'm not sure WHY. I got the 26mhz tone. I changed the sketch to 7200 and got the tone on 7202.20. So, then I changed it to 7.075 and could hear it on

Mine came via DHL though I did not order carrier service. I just assumed that Ashar and the Elves were adding a bit of Seasons Spirit for the early batch to get here ahead of Christmas. At any rate,

Was wondering if I could adjust the rf out from 10 to 5 Watts. ?I have an amp I would like to use but the amps max power in is 5 Watts. Can I adjust the drive to lower the rf out? Art - N2AJO

How do you calibrate the frequency on uBit? I have not figured out the menu yet! I do get WWV now on about 15' of wire out the door.? I can Zero beat it and get the AM at 9.8 something? Mike,

Going into transmit, C 63 should pass a big transient through C 50 into Q 70 base which still has power because nothing quickly discharges C52, and U1 always has power. Sent from my iPhone

John, The screen says to press PTT to set the new setting but I found the button on the encoder works. Regards Simon VK3ELH

Ordered on the 10th. Received Paypal tracking on the 19th. Received today 20th (Upstate NY, USA) Gene N2IJF ________________________________ Sent: Wednesday, December 20, 2017 6:18 PM To:

Hope no one minds me posting this but no bites on the zed so I thought I might post it where more qrpers might see

I found the same thing with a straight key, decent performance with a paddle. Yes, the pops going into transmit are a bit annoying. Perhaps a simple transistor switch to break the audio connection

Franz, perhaps a stupid question: Did you enable the touch sensors in the SETTINGS menu? (they are OFF by default). Press Function Button 5 seconds => SETTINGS menu press FB two times (set CW

Hi Franz, please install the attached diagnostic sketch "arduino_diag_v3.ino". Keep your Raduino connected to your PC. In your IDE, go to "tools" and "Serial Monitor". A window will pop up showing

At some point,we probably will need to focus in on that flash,bang and burnt smell you reported? when first taking your voltage measurements around the mosfet but the immediate task is to confirm

I too have a birdie on 7.120...not a too much of a problem here as it's high into the CW portion...

Hi Marco Tnx for the info, But the radios are coming to UK via Royal Mail…maybe their tracking system will show something 73 , Charlie GI4FUE Sent: 20 December 2017 21:56 To:

I realize that one of my statements wasn’t that clear. The mic element is fine (but varies by manufacturer), but the speakers do not have good audio! There is no need to replace the mic element.