开云体育

Need help troubleshooting. #sketch-too-big
For those who have successfully installed the latest drop of N8ME_2_VU3GAO_Mods, what Arduino ISP version are you using?

-What are the parameters in the ISP you are using for a "stock" uBITX V6 complete kit? I have noodled with several:?
-Board: Arduino Mini
-Processor: ATmega328P
-Programmer ArdunoISP (and a couple of similar appearing entries)

I am getting the infamous "Sketch too big" error even after playing with several versions of the ISP and following Ashhar's description of compiling and loading the sketch.
part of error message reads: text section exceeds available space in board Sketch used 29214 bytes(101%) of available space. Maximum is 288672 bytes.
I don't mess with Arduino enough to have a clue what to comment out or otherwise eliminate that would allow a good compile. Have read something about eliminating the boot loader from compile, but isn't boot loader required to init the firmware?

Currently have ISP 1.8.12 installed.
Pretty obvious some parameter or other is not right and I am unable to prevent the bloat on compile.
A search of the messages found a lot addressing the issue for other firmware, but little useful for the N8ME/VU3GAO version.

Thanks in advance for any clear text, non jargon laden explanations offered.

73 -
Jack KD4IZ