Hi Milarepa,
based on my measurements, it is only a few mw, so the oposite of
what Allison measured.
I searched for you in the older postings (I have often the feeling
that older messages are not red) and you can find my answer in
message 375 (containing a mistake) and 387.
Good luck,
Chris.
--- In BITX20@..., "ajparent1" <kb1gmx@a...> wrote:
Based on my proto 300mW is correct. If there were 300mV the power
would be about 2mW which is way to little.
Allison
KB1GMX
--- In BITX20@..., "MILAREPA" <MILAREPA@T...> wrote:
Dear forum,
I have read somewhere from the posting messages that the output
of pre
driver should be about 300 mWatts,
but I read from the article it should be about 300 mVolts.
Which is right ?
-------
I begin to test the tx section,
rx section test is good in 3.5; 7; 10; 14 MHz.
-------
Thanks.
