On Fri, May 8, 2020, 11:45 AM Richard West via <rewest71=[email protected]> wrote:
Quick question about changing and saving mode for desired frequency. When the unit is turned on, it always goes to program default of 7.150khz, LSB on BFO A.
I have tried to save a local AM radio station frequency of 1.410khz for convenience. My radio is typically enjoyed for listening the lower band stations.
Have tried to get on the air in CW mode. No joy with the 700hz tone slipping the frequency up or down in CWU or CWL by that much. Used separate xcvr to check transmit frequency, and it was off, and not confident using it on the air.
I've tried to save this frequency (1.410khz) and mode USB) with the CEC program. It would not transfer it or USB mode to memory the unit for use later. As a work around saved the frequencies and mode into memory. Is there a way to have the desired frequency showing at boot up, without twiddling the dial to the saved frequency selections? Thank you in advance for assistance.
