Ken,
You may find this short video useful at an introduction to the Arduino family even though it's not specific to the uBITX:
- Bill KB3T
toggle quoted message
Show quoted text
On 2019-12-30 11:47, Ken Hansen wrote:
With my new V6 uBitx competed (Latest design, bought with case) I've
seen/heard there were some small software issues, discovered as the
units are tested. I'm not an arduino or github guru, and I suspect
many here are like me - willing to tinker, but this github/arduino
ecosystem is totally new to me.
Does anyone have a link to a document/webpage that outlines the needed steps to:
1) set up a computer to load software onto uBitx,
2) download corrected software (once available),
3) load corrected software onto uBitx,
And 4) perform any needed calibration/alignment once loaded?
I understand updated software is not available yet, But I want to be
ready when it is.
Thanks in advance,
Ken, N2VIP
