Re: V6 mic connector - compatibility
|
It is wired with a 3.5 mm audio jack. The tip is mic, the ring is ptt and the sleeve is ground. It was kept this way so you can use regular audio cables to the computer.
Iz Oss
Properly wired it it is compatible with any rig that supports an electret type microphone.?
These have an internal FET that needs a small voltage and possibly a DC isolating
capacitor (capacitor need depends on circuit layout).?
If one wants to use a standard Icom, Yaseu, etc. microphone with a uBITX? then you
need to know the circuit layout of that unit and adapt your microphone to that layout.?
Dynamic or crystal microphones may not provide sufficient signal output to drive an
input that is designed for an electret microphone.? Dynamic microphones may also
require an isolating capacitor to block DC? from the microphone and a resistor to
adjust microphone DC bias to what it would be if an electret microphone were used.?
Arv? K7HKL _._
Hi all, I see the ubitx V6 comes with a stock mic. Is this compatible to any brand, Icom, Yaesu or Kenwood?
|
