Erwin there is a good reason for what you experienced with the active antenna the uBITX antenna input looks like a short for DC. This is because the antenna input is connected via a low pass filter to T2 of the mixer. If you measured the uBITX antenna input with a ohmmeter you will see zero ohms.?
If you install a capacitor in series with the input to isolate DC on the active antenna on the uBITX side you should be fine.?
toggle quoted message
Show quoted text
On Dec 11, 2019, at 07:29, Erwin Serl¨¦ via Groups.Io <waterwin2@...> wrote:
?I have a loosely soldered uBITx on my work area connected to a 12V power supply and a headphone. Nothing properly mounted , shielded etc.
Just to hear some RF coming in as the kit arrived just some hours ago.
I works, with hum, other sounds etc. As expected. Power supply shows 166 mA current at 12V.
Then I changed the coax coming from one of my normal antenna's into a coax coming from my active antenna. A design by PE0RDT also known as mini-whip.
The electronics receive their power via the coax going out and connected to another 12V power supply.
This is a BAD idea.
I saw strange flickering on the uBITx display, going on and off, and also the same on the first 12V power supply powering the uBITx board. And I noticed smoke coming from the coax, at both sides, into the uBITx and at the power/connector box to the active antenna.
I pulled the 12V from the active antenna, pulled the (warm and melted) coax from both sides, switched of the 12V powering the uBITx board.
After connecting a normal antenna all is well again.
Possibly there is (quite) some difference between the 2 ground potentials of the 2 different supplies. I will need to measure this ;-)
Later...
When I have grounded all things great and small, and have a good metal enclosure etc.
--
PE3ES - F4VTQ - Erwin
73
Skip Davis